We have developed a code-division-multiplexing (CDM) transmission scheme for future road-vehicle communication systems, which uses cyclic shifted-and-extended (CSE) codes generated from a basic code with superior auto-correlation characteristics. This paper proposes to use a Quasi-Orthogonal (QO) sequence as the basic code. Its auto-correlation values are zero except at zero and middle shifts. When the CDM transmission is performed by the CSE codes based on the QO sequence, a desired correlation value is, at a receiver, interfered by the auto-correlation value at middle shift. Therefore, an elimination technique for the interfered correlation value is proposed and realizes zero cross-correlation characteristics within the cyclical shift interval. The new CDM transmission scheme based on the proposed scheme is evaluated by computer simulations in terms of the bit-error-rate performance.

In this study, edge diffraction of an electromagnetic plane wave by two-dimensional conducting wedges has been analyzed by the physical optics (PO) method for both E and H polarizations. Non-uniform and uniform asymptotic solutions of diffracted fields have been derived. A unified edge diffraction coefficient has also been derived with four cotangent functions from the conventional angle-dependent coefficients. Numerical calculations have been made to compare the results with those by other methods, such as the exact solution and the uniform geometrical theory of diffraction (UTD). A good agreement has been observed to confirm the validity of our method.

Plane wave scattering from a circular conducting cylinder and a circular conducting strip has been formulated by equivalent surface currents which are postulated from the scattering geometrical optics (GO) field. Thus derived radiation far fields are found to be the same as those formulated by a conventional physical optics (PO) approximation for both E and H polarizations.

A novel delta-sigma modulator that employs a non-uniform quantizer whose spacing is adjusted by reference to the statistical properties of the input signal is proposed. The proposed delta-sigma modulator has less quantization noise compared to the one that uses a uniform quantizer with the same number of output values. With respect to the quantizer on its own, Lloyd proposed a non-uniform quantizer that is best for minimizing the average quantization noise power. The applicable condition of the method is that the statistical properties of the input signal, the probability density, are given. However, the procedure cannot be directly applied to the quantizer in the delta-sigma modulator because it jeopardizes the modulator's stability. In this paper, a procedure is proposed that determine the spacing of the quantizer with avoiding instability. Simulation results show that the proposed method reduces quantization noise by up to 3.8 dB and 2.8 dB with the input signal having a PAPR of 16 dB and 12 dB, respectively, compared to the one employing a uniform quantizer. Two alternative types of probability density function (PDF) are used in the proposed method for the calculation of the output values. One is the PDF of the input signal to the delta-sigma modulator and the other is an approximated PDF of the input signal to the quantizer inside the delta-sigma modulator. Both approaches are evaluated to find that the latter gives lower quantization noise.

An electromagnetic wave scattering by a material loaded rectangular trough on a ground plane is approximately analyzed by using standard impedance boundary condition (SIBC). The validity of the derived approximate solution is examined by comparing with the rigorous one not only for the oblique incidence but also for the variation of both the filled material's parameters and the trough dimension. An applicability condition has been derived here for this trough structure.

Diffraction field by a wide and thick slit on a conducting screen has been analyzed. High frequency ray-mode coupling analysis has been utilized, and the total diffracted or radiated field in each region is considered as a summation of successive modal radiation contribution due to the original modal excitation by the incident plane wave. Our derived results are compared with those obtained by other solutions, and good agreement has been observed, and the validity of our formulation is confirmed.

In order to realize a future seamless high-speed road-vehicle communication system, we have proposed using code division multiplexing (CDM) radio transmission scheme by using cyclic shifted-and-extended (CSE) codes as spread codes. As the CSE codes are generated by cyclically shifting and extending a conventionally used code, the number of codes generated from a code is limited to the length of the shift interval and the tolerable period of delayed waves also depends on the length. In this paper, based on CSE codes, we propose a method to minimize the length of the shift interval and a cancellation technique with a simple calculation in order to eliminate the interference from delayed waves caused by the reduction of the length of shift interval. The concept and the BER performances in AWGN, two-paths, and multi-path fading environments are described in this paper. As a result, the maximum transmission rate of CSE-based-CDM transmission per one-code using the newly proposed transmission scheme is 3 times as large as that using conventional CSE codes and DQPSK-CDM transmission scheme.

In this study, the electromagnetic scatterings from conducting bodies have been investigated via a surface equivalence theorem. When one formulates equivalent electric and magnetic currents from geometrical optics (GO) reflected field in the illuminated surface and GO incident field in the shadowed surface, it has been found that the asymptotically derived radiation fields are found to be the same as those formulated from physical optics (PO) approximation.

Time transient scattering field dur to a line source located at the center of the dielectric cylinder has been calculated. In the analysis, the corresponding time harmonic result has been formulated first rigorously, then the high frequency asymptotic expansion result has been derived. Thus obtained result is found to coincide wiht the one constructed directly by ray approximation. Fourier invesion for an impulsive response has been done by two methods, namely the Singularity Expansion Method and wavefront expansion method. While the former method collects the contributions around the singularities in the complex frequency domain, the latter gives us a result which is a summation of each successive wavefront arrivals. A finite Hilbert transform technique has been introduced to recover the causal responses of odd-time caustic passing wavefronts. Also derived are results of numerical inversion by Fast Fourier Transform Technique for the frequency band limited incident pulses. A Gaussian pulse has been introduced to simulate an impulse response result, and a raised cosine pulse which de-emphasizes the low frequency defects of asymptotically constructed frequency spectrum confirms the usefulness of ray solution.

This paper presents an easy and efficient modification of simplified 2D ray-launching method, by approximately including multiple reflection effect inside walls for indoor environment. In order to precisely carry out the ray-launching procedure inside lossy wall, a simple modification using a true real refraction angle is first introduced, instead of complex one. Furthermore, an efficient approximation is carried out to collect the internal multiple reflected rays into the primary one. We here call it collective ray approach. Consequently, it is confirmed from the detailed considerations that the present ray representations obtained by introducing the real refraction angle are well suitable for indoor propagation analysis, and in particular the collective ray solution can be utilized confidently even when the internal reflections strongly contribute to the propagation feature of the considered indoor environment.

Electromagnetic plane wave scattering by a loaded trough on a ground plane has been analyzed by Kobayashi and Nomura's method. The field in each region is expressed first in terms of appropriate eigen functions, whose excitation coefficients are determined by the continuity condition across the aperture of the trough. Simple far field expression which is suitable for numerical calculation for small aperture cases has been derived. Scattering far field patterns and radar cross section are calculated and compared with those obtained by other methods. Good agreements have been observed for all incident angles.

A simple approach is presented for designing an antipodal Vivaldi antenna in this paper. A new and better estimation of the low frequency end of the operational range is shown. Final dimensions of the antenna parameters are determined by using the High Frequency Structure Simulator (HFSS). The proposed antenna has a simple configuration but exhibits low return loss, good radiation characteristics, and high and flat gain in the operating ultra wideband frequency range (3.1-10.6 GHz). Lastly, the fabrication has been done along with the specification to confirm the properties by measurements.

This paper presents an efficient ray-launching method for 2D indoor propagation problem, by including crucial multiple reflection effect inside wall. We here focus on the derivation of the reflected and transmitted ray solutions at/through wall when a magnetic source is located in the indoor environment. An efficient approximation, which is called collective ray approximation, is carried out to bundle or collect the internal multiple reflected rays into the primary one. It is resultantly confirmed from the detailed numerical experiments that the derived collective ray solutions can be confidently effective when the internal reflections strongly contribute to the propagation characteristic in the propagation environment, regardless of angle of the incidence.

Electromagnetic scattering of an electromagnetic plane wave from a rectangular hole in a thick conducting screen is solved using the Kirchhoff approximation (KA). The scattering fields can be derived as field radiations from equivalent magnetic current sources on the aperture of the hole. Some numerical results are compared with those by the Kobayashi potential (KP) method. The proposed method can be found to be efficient to solve the diffraction problem for high frequency regime.

A simple non-destructive depth estimation method for a crack on a metal surface has been proposed. This method is based on our finding that the electromagnetic back scattering from a narrow trough (crack model) on the ground plane causes periodical nulls (dips) as the frequency changes, and the first dip occurs when the depth of the crack becomes nearly one half of the incident wavelength. Dependencies of the crack's aperture and the incident angle have also been studied from rigorous and numerical analyses, and considered as our depth estimation parameters. A simple estimation formula for a crack depth has been derived from these studies. Test measurement has been made to check the accuracy of our estimation formula. Time domain gating process is utilized for isolating the crack scattering spectra buried in the measured frequency RCS data. Tested crack types are a narrow rectangular, a tapered, and a stair approximated crack shapes. It is found that the depth of these cracks can be measured within 3 percent error by our estimation method.

A broadband approach to estimate the relative permittivity of dielectric cuboids has been proposed for materials of weak frequency dispersive characteristic. Our method involves a numerical iterative scheme with appropriate initial values carefully selected to solve for the relative permittivity in a wide range of frequencies. Good agreements between our method and references have been observed for nylon and acrylic samples. An applicable range relation between the minimal thickness, the frequency range and the dielectric property of the material has also been discussed.

In this paper, the scattering far-field from a circular electric conducting cylinder has been analyzed by physical optics (PO) approximation for both H and E polarizations. The evaluation of radiation integrations due to the PO current is conducted numerically and analytically. While non-uniform and uniform asymptotic solutions have been derived by the saddle point method, a separate approximation has been made for forward scattering direction. Comparisons among our approximation, direct numerical integration and exact solution results yield a good agreement for electrically large cylinders.

We investigated the radio propagation characteristics for line-of-sight (LOS) inter-vehicle communication (IVC) at 60 GHz on an actual road with an undulating surface. Radio propagation tests between two moving vehicles were carried out on a test course. From this, it was found that the measured received power on the actual road and the results calculated for a flat road approximately follow logarithmic normal distributions. To investigate this phenomenon in detail, a propagation test between two stationary vehicles on a road was performed. Furthermore, calculations using geometrical optics taking road undulation into consideration demonstrated that undulation in the road can cause variations in the received power that follow a logarithmic normal distribution. Finally, the received power for moving vehicles on an undulating road was calculated using the model.