In wireless LANs, wireless clients are associated with one of access points (APs) to obtain network connectivity, and the AP performs network traffic relay between the wired infrastructure and wireless clients. If a client with a low transmission rate is associated with an AP, the throughput performance of all the clients that are associated with the AP is significantly degraded because of the long channel usage time of the low-rate client. Therefore, it is important to select an appropriate AP when a new client joins the wireless LAN to prevent the performance degradation. In this paper, we propose a traffic control that determines the feasible data traffic from an AP to the clients on the basis of the trade-off relationship between the equal-throughput and equal-airtime traffic allocation policies. We then propose a network-wide association algorithm that allows a client to be associated with the AP that can provide the highest throughput improvement. Simulation results indicate that the proposed algorithm achieves the better aggregate throughput and throughput fairness performances in IEEE 802.11 WLANs.

This letter presents a reconfigurable antenna with a microstrip patch that uses PIN-diode connections on slits to achieve frequency diversity. By switching the diodes on or off, a surface current path on the antenna is changed, which effectively results in shifting the operating frequency. Thus the antenna can select both WiBro and DMB bands.

In wireless networks, interference from adjacent nodes that are concurrently transmitting can cause packet reception failures and thus a significant throughput degradation. The interference can be simply avoided by assigning different orthogonal channels to each interfering node. However, if the number of orthogonal channels is smaller than that of interfering nodes, some adjacent nodes have to share the same channel and may interfere with each other. This interference can be mitigated by reducing the transmit power of the interfering nodes. In this paper, we propose to jointly coordinate the transmit power and the multi-channel allocation to maximize the network throughput performance by fully exploiting multi-channel availability. This coordination enables each node to use high transmission power as long as different orthogonal channels can be assigned to its adjacent nodes. Then, we propose a simple multi-channel media access control (MAC) protocol that allows the nodes on different channels to perform efficient data exchanges without interference in multi-channel networks. We show that the proposed scheme improves the network throughput performance in comparison with other existing schemes.

This paper presents a planar monopole antenna with slits and a stub for multi-band operation in vehicles. The proposed antenna is at least 55% smaller than the regular rectangular monopole antenna and covers eight wireless application bands. Slits cut into the rectangular monopole alter the surface current paths so that the band coverage is expanded. A long bent-stub is also added to cover the lowest service band.

Co-ferrite thin films have been fabricated on Corning glass substrates by a chelating sol-gel process. Structural and magnetic properties of the films have been studied as a function of annealing temperature using an X-ray diffraction (XRD) and a vibrating sample magnetometer. XRD results revealed that most of the Co-ferrite grains were randomly oriented. Rapid annealing (RA) and standard annealing (SA) processes were used for the variation of heat treatment and the characteristic comparison. Coercivity was changed with the thermal condition and the magnetization increased with the soaking time. With prolonged soaking time, however, the coercivity decreased due to the diffusion of cations from the glass substrate. RA in the preparation of Co-ferrite thin films was effective for preventing interdiffusion at interfaces and for forming a single phase in the case of reduced soaking time. A yttria stabilized zirconia (YSZ) buffer layer between the Co-ferrite layer and the substrate was effective for improving the magnetic properties of the films at higher temperatures. It was observed that Co-ferrite thin films were composed of grains typically 35 nm in size and their rms roughness was approximately 1.3 nm. The saturation magnetization of the thin films by subjected to rapid annealing at 900C for 150 seconds was 400 emu/cm3 and the coercivity of the films was approximately 3000 Oe.