This paper clarifies the effects of metal wires placed around a Multiple-Input-Multiple-Output (MIMO) array with the goal of improving the channel capacity in near-field MIMO systems. Tests are performed on dual-dipole arrays with metal wires placed parallel to the dipoles. If the antenna elements have an appropriate half-power beamwidth (HPBW), there is a clear improvement in the channel capacity of the dual-dipole array. The metal wires are used to increase the multipath richness and the locations of the wires significantly impact the channel capacity. A significant increase in the channel capacity is observed even if only one metal wire is placed in the proper location. We verified the generality of applying a metal wire to improve the channel capacity and that the improvement in the channel capacity is approximately proportional to the number of metal wires.

This paper presents a compact metal plate lens antenna for evaluating a wave absorber placed on ceiling of the ETC gate. The focal distance of the lens was derived to be 129 cm by the geometrical optics procedure. By arranging the lens in front of a horn antenna, the gain and beamwidth characteristics were improved from 18 dBi to 26 dBi and from 22 degrees to 7 degrees, respectively. Then the antenna characteristics were evaluated when the distance between the antenna and the lens was changed in order to miniaturize the lens antenna. As the result, the changes in beamwidth were held to within 1 dB when the lens came close to the horn antenna. Scattering, phase and electric field intensity of electromagnetic wave were evaluated to clarify the foundation of the given characteristics. It was found that the field intensity for the miniaturized lens antenna is stronger than that for GO designed one though the phase uniformity is worse. The distance between the horn antenna and lens can be reduced to 80 cm. The absorption characteristics for the arranged absorbers which have different absorptions were measured, and it was shown that the proposed method was suitable for specifying the deteriorated absorber in the ETC system.