To reduce the common mode voltage (CMV), suppress the CMV spikes, and improve the steady-state performance, a simplified reactive torque model predictive control (RT-MPC) for induction motors (IMs) is proposed. The proposed prediction model can effectively reduce the complexity of the control algorithm with the direct torque control (DTC) based voltage vector (VV) preselection approach. In addition, the proposed CMV suppression strategy can restrict the CMV within ±Vdc/6, and does not require the exclusion of non-adjacent non-opposite VVs, thus resulting in the system showing good steady-state performance. The effectiveness of the proposed design has been tested and verified by the practical experiment. The proposed algorithm can reduce the execution time by an average of 26.33% compared to the major competitors.

In this study, we propose a two-step approach to evaluate electromagnetic interference (EMI) with a wearable vital signal sensor. The two-step approach combines a quasi-static electromagnetic (EM) field analysis and an electric circuit analysis, and is applied to the EMI evaluation at frequencies below 1 MHz for our developed wearable electrocardiogram (ECG) to demonstrate its usefulness. The quasi-static EM field analysis gives the common mode voltage coupled from the incident EM field at the ECG sensing electrodes, and the electric circuit analysis quantifies a differential mode voltage at the differential amplifier output of the ECG detection circuit. The differential mode voltage has been shown to come from a conversion from the common mode voltage due to an imbalance between the contact impedances of the two sensing electrodes. When the contact impedance is resistive, the induced differential mode voltage increases with frequency up to 100kHz, and keeps constant after 100kHz, i.e., exhibits a high pass filter characteristic. While when the contact impedance is capacitive, the differential mode voltage exhibits a band pass filter characteristic with the maximum at frequency of around 150kHz. The differential voltage may achieve nearly 1V at the differential amplifier output for an imbalance of 30% under 10V/m plane-wave incident electric field, and completely mask the ECG signal. It is essential to reduce the imbalance as much as possible so as to prevent a significant interference voltage in the amplified ECG signal.

A scalable low voltage signaling (SLVS) transmitter, with asymmetric impedance calibration, is proposed for mobile applications which require low power consumption. The voltage swing of the proposed SLVS transmitter is scalable from 40,mV to 440,mV. The proposed asymmetric impedance calibration asymmetrically controls the pull-up and pull-down drivers for the SLVS transmitter with an impedance of 50,$Omega$. This makes it possible to remove the additional regulator used to calibrate the impedance of an output driver by controlling the swing level of a pre-driver. It also maintains the common mode voltage at the center voltage level of the transmitted signal. The proposed SVLS transmitter is implemented using a 0.18-$mu $m 1-poly 6-metal CMOS process with a 1.2-V supply. The active area and power consumption of the transmitter are $250 imes 123 mu$ m$^{2}$ and 2.9,mW/Gb/s, respectively.