Electromagnetic field probes inevitably disturb the original distribution of the field when they are positioned close to a device. This disturbance in turn affects measurement accuracy and device operation. We developed an optical magnetic field probe, comprising a loop antenna element and an electro-optic crystal, for highly accurate magnetic near-field measurement in the GHz frequency range. We analyzed the invasiveness of the optical magnetic field probe quantitatively both experimentally and using finite difference time domain simulation. We found that eliminating the metal cable reduced the disturbance of the surrounding field that was to be measured. In addition, we investigated the magnetic field detection characteristics of the probe and its influence on the operation of a microstrip line. The optical magnetic field probe was less invasive and provided more accurate measurement.

An electric filed sensor using Mach-Zehnder interferometers has been designed to operate more than 10 GHz. The velocity of optical wave on the waveguide is investigated to determine the electrode length, and the characteristics of frequency response are analyzed using the moment method to determine the sensor element length. The electrode length of 1 mm and the element length of 8 mm are settled by these investigations. An isotropic electric field sensor is constructed using three sensors. The minimum detectable electric field strength is 22 mV/m at frequency bandwidth of 100 Hz. This is about 100 times for the conventional electric field sensor using the similar element. The sensitivity deviation is within 3 dB when temperature changes from 0 degree to 40 degree. The deviation of directivity can be tuned within 1 dB to calibrate the sensitivity of the each element. The sensitivity degradation is within 6 dB up to 5 GHz and within 10 dB up to 10 GHz. This is almost agree with the calculated results. The sensor can measure almost the same waveform as the applied electric field pulse whose width is 6 ns and rise time is less than 2.5 ns.

The design method for sensitivity and frequency response of an electric field sensor using a Mach-Zehnder interferometer (an optical E-field sensor) has been developed in order to measure electromagnetic environments and the performance of measuring facilities. The designs of the optical modulator, sensor elements, and sensitivity were analyzed theoretically by using an accurate equivalent circuit of the sensor. Then an actual sensor was fabricated, and its characteristics of the sensor were evaluated experimentally. The results show that the designed sensitivity and frequency response were optimal. The optical output deviation when the temperature increased from 0 to 40 was reduced to within 2 dB. The minimum detectable electric field strength was 17 dBµV/m (8 µV/m), and the dynamic range was more than 100 dB. The frequency response of the sensitivity was almost flat between 200 Hz and 900 MHz.