Achieving optimal performance with minimal complexity are conflicting problems encountered in constructing receivers. In this paper, to solve the problem, we propose sector beamed space hopping which utilizes a Viterbi equalizing receiver. Reduction of the number of RF circuit sets, system complexity and decreasing the computational burden of the Viterbi equalizer through the use of sector beamed space hopping is presented. This is achieved using a sector beamed antenna which limits the number of paths in the multipath channel environment. This paper describes each key component which comprises the system and discusses the application of FH-SS communication. The channel is assumed to be an industrial indoor propagation channel, such as those found in a factory, where high reliability is required and many complex multipaths exist. We confirm through simulation that Viterbi equalization using less computational complexity can be obtained. It is found that there exists a trade off between system complexity and performance. Through the discussion of power consumption, cost and BER performance, we show that the proposed system achieves acceptable performance while having a low system complexity.

This paper proposes a newly developed dual-frequency antenna for 800 MHz and 1500 MHz band use. A uniformly spaced array configuration, originally designed for a 800 MHz analog system, is extended to yield dual frequencies operations. An important characteristic of a base station antenna is low sidelobe level in order to suppress inter-cell interference. In the case of a uniformly spaced array configuration, sidelobe levels are increased by the emergence of grating lobes at higher frequencies. Electrical beam tilt also degrades the sidelobe level. As does the change in the excitation coefficients of the array elements at higher frequencies. These three factors are studied theoretically to yield practical sidelobe levels. One more important beam characteristic is the sector beam in the horizontal plane. The same beam width in two frequency bands is achieved by designing the novel reflector shape and determining the proper array element positions in front of the reflector. Practical antenna characteristics are confirmed by designing, manufacturing, and testing a base station antenna.

A new beam tilt dipole array antenna in a simple structuer has been developed for indoor base stations in the 1.9 GHz band. The antenna comprises a radiator and skewed off-center parasitic elements placed around the radiator. With this stucture, the main beam of the array antenna can be tilted for mobile terminals reception by the effect of mutual coupling. Studies on tilt characteristics for antenna dimensions and tilt mechanism by precise current measurements have clarified the operating principle. The antennas with a fan beam and an omnidirectional pattern have been designed. The measured tilt angle was varied in the range of 0 to 26 with little alteration of the horizontal radiation patterns.