Transition coverage has been proposed as a measure of two-pattern test capabilities of TPG circuits for use in BIST. This paper investigates experimentally the relationships between transition coverages and actual stuck-open fault coverages in order to reveal what kind of circuits are appropriate for two-pattern testing. Fault simulation was performed using conventional (n-stage) LFSR, 2n-stage LFSR, and one-dimensional cellular automata (CAs) as TPG circuits and such sample circuits as balanced NAND tree and some ISCAS '85 benchmark circuits as CUTs. It was found that CAs which are designed so as to apply exhaustive transitions to any 3-dimensional subspaces can detect high rate of stuck-open faults. Influence of hazards of decreasing the fault coverage is also mentioned.

Chip multiprocessors (CMPs) improve performance by simultaneously executing multiple threads using integrated multiple cores. However, since these cores commonly share one cache, inter-thread cache conflicts often limit the performance improvement by multi-threading. This paper focuses on two causes of inter-thread cache conflicts. In shared caches of CMPs, cached data fetched by one thread are frequently evicted by another thread. Such an eviction, called inter-thread kickout (ITKO), is one of the major causes of inter-thread cache conflicts. The other cause is capacity shortage that occurs when one cache is shared by threads demanding large cache capacities. If the total capacity demanded by the threads exceeds the actual cache capacity, the threads compete to use the limited cache capacity, resulting in capacity shortage. To address inter-thread cache conflicts, we must take into account both ITKOs and capacity shortage. Therefore, this paper proposes a capacity-aware thread scheduling method combined with cache partitioning. In the proposed method, inter-thread cache conflicts due to ITKOs and capacity shortage are decreased by cache partitioning and thread scheduling, respectively. The proposed scheduling method estimates the capacity demand of each thread with an estimation method used in the cache partitioning mechanism. Based on the estimation used for cache partitioning, the thread scheduler decides thread combinations sharing one cache so as to avoid capacity shortage. Evaluation results suggest that the proposed method can improve overall performance by up to 8.1%, and the performance of individual threads by up to 12%. The results also show that both cache partitioning and thread scheduling are indispensable to avoid both ITKOs and capacity shortage simultaneously. Accordingly, the proposed method can significantly reduce the inter-thread cache conflicts and hence improve performance.

As energy consumption of cache memories increases, an energy-efficient cache management mechanism is required. While a dynamic cache resizing mechanism is one promising approach to the energy reduction of microprocessors, one problem is that its effect is limited by the existence of dead-on-fill blocks, which are not used until their evictions from the cache memory. To solve this problem, this paper proposes a cache management policy named FLEXII, which can reduce the number of dead-on-fill blocks and help dynamic cache resizing mechanisms further reduce the energy consumption of the cache memories.

A hybrid memory architecture (HMA) that consists of some distinct memory devices is expected to achieve a good balance between high performance and large capacity. Unlike conventional memory architectures, the HMA needs the metadata for data management since the data are migrated between the memory devices during the execution of an application. The memory controller caches the metadata to avoid accessing the memory devices for the metadata reference. However, as the amount of the metadata increases in proportion to the size of the HMA, the memory controller needs to handle a large amount of metadata. As a result, the memory controller cannot cache all the metadata and increases the number of metadata references. This results in an increase in the access latency to reach the target data and degrades the performance. To solve this problem, this paper proposes a metadata prefetching mechanism for HMAs. The proposed mechanism loads the metadata needed in the near future by prefetching. Moreover, to increase the effect of the metadata prefetching, the proposed mechanism predicts the metadata used in the near future based on an address difference that is the difference between two consecutive access addresses. The evaluation results show that the proposed metadata prefetching mechanism can improve the instructions per cycle by up to 44% and 9% on average.

In this paper, we propose a placement and routing method for a new memory-based programmable logic device (MPLD) and confirm its capability by placing and routing benchmark circuits. An MPLD consists of multiple-output look-up tables (MLUTs) that can be used as logic and/or routing elements, whereas field programmable gate arrays (FPGAs) consist of LUTs (logic elements) and switch blocks (routing elements). MPLDs contain logic circuits more efficiently than FPGAs because of their flexibility and area efficiency. However, directly applying the existing placement and routing algorithms of FPGAs to MPLDs overcrowds the placed logic cells and causes a shortage of routing domains between logic cells. Our simulated annealing-based method considers the detailed wire congestion and nearness between logic cells based on the cost function and reserves the area for routing. In the experiments, our method reduced wire congestion and successfully placed and routed 27 out of 31 circuits, 13 of which could not be placed or routed using the versatile place and route tool (VPR), a well-known method for FPGAs.

Vector processors have significant advantages for next generation multimedia applications (MMAs). One of the advantages is that vector processors can achieve high data transfer performance by using a high bandwidth memory sub-system, resulting in a high sustained computing performance. However, the high bandwidth memory sub-system usually leads to enormous costs in terms of chip area, power and energy consumption. These costs are too expensive for commodity computer systems, which are the main execution platform of MMAs. This paper proposes a new multi-banked cache memory for commodity computer systems called MVP-cache in order to expand the potential of vector architectures on MMAs. Unlike conventional multi-banked cache memories, which employ one tag array and one data array in a sub-cache, MVP-cache associates one tag array with multiple independent data arrays of small-sized cache lines. In this way, MVP-cache realizes less static power consumption on its tag arrays. MVP-cache can also achieve high efficiency on short vector data transfers because the flexibility of data transfers can be improved by independently controlling the data transfers of each data array.

This paper proposes an efficient reference image sharing method for the image-division parallel video encoding architecture. This method efficiently reduces the amount of data transfer by using pre-transfer with area prediction and on-demand transfer with a transfer management table. Experimental results show that the data transfer can be reduced to 19.8-35.3% of the conventional method on average without major degradation of coding performance. This makes it possible to reduce the required bandwidth of the inter-chip transfer interface by saving the amount of data transfer.