This paper proposes a novel sub-architecture to optimize the data flow of REMUS-II (REconfigurable MUltimedia System 2), a dynamically coarse grain reconfigurable architecture. REMUS-II consists of a µPU (Micro-Processor Unit) and two RPUs (Reconfigurable Processor Unit), which are used to speeds up control-intensive tasks and data-intensive tasks respectively. The parallel computing capability and flexibility of REMUS-II makes itself an excellent candidate to process multimedia applications, which require a large amount of memory accesses. In this paper, we specifically optimize the data flow to deal with those performance-hazard and energy-hungry memory accessing in order to meet the bandwidth requirement of parallel computing. The RPU internal memory could work in multiple modes, like 2D-access mode and transformation mode, according to different multimedia access patterns. This novel design can improve the performance up to 26% compared to traditional on-chip memory. Meanwhile, the block buffer is implemented to optimize the off-chip data flow through reducing off-chip memory accesses, which reducing up to 43% compared to direct DDR access. Based on RTL simulation, REMUS-II can achieve 1080p@30 fps of H.264 High Profile@ Level 4 and High Level MPEG2 at 200 MHz clock frequency. The REMUS-II is implemented into 23.7 mm2 silicon on TSMC 65 nm logic process with a 400 MHz maximum working frequency.

TTFF (Time-To-First-Fix) is an important indicator of GPS receiver performance, and must be reduced as much as possible. Bit synchronization is the pre-condition of positioning, which affects TTFF. The frequency error leads to power loss, which makes it difficult to find the bit edge. The conventional bit synchronization methods only work well when there is no or very small frequency error. The bit synchronization process is generally carried out after the pull-in stage, where the carrier loop is already stable. In this paper, a new bit synchronization method based on frequency compensation is proposed. Through compensating the frequency error, the new method reduces the signal power loss caused by the accumulation of coherent integration. The performances of the new method in different frequency error scenarios are compared. The parameters in the proposed method are analyzed and optimized to reduce the computational complexity. Simulation results show that the new method has good performance when the frequency error is less than 25Hz. Test results show that the new method can tolerate dynamic frequency errors, and it is possible to move the bit synchronization to the pull-in process to reduce the TTFF.

In 2006, Miranda et al. proposed an anonymity scheme to achieve peers' anonymity in Peer-to-Peer (P2P) reputation systems. In this paper, we show that this scheme can not achieve peers' anonymity in two cases. We also propose an improvement which solves the problem and improves the degree of anonymity.