Sliding contact behavior is important in the mechanism of collecting current. In this study, the effect of ambient gas including an inert gas on surface film formation and on the contact voltage drop was examined, changing the atmosphere from low pressure to atmospheric pressure. Furthermore, the sliding surface state was observed using SEM, EDX and XPS analyzers after the test operation. As a result, at the sliding contact in an inert gaseous environment (nitrogen and argon), it was confirmed that the contact voltage drop tends to increase. However, it was clarified that any chemically generated surface film is difficult to detect in the inert gas environment by qualitative analysis. On the basis of these results, we suggest the existence of physically adsorbed surface film. The relationship between inert gases and sliding contact phenomena is discussed.

The authors have been investigating degradation process of Au plated slip ring and Ag-Pd-Cu brush system. In almost all cases the lifetime of the sliding system ends, when Au plating layer is worn out, the ring surface is oxidized to be black in color and contact resistance becomes very high. Further, the lifetime is very short without lubricant. So, the lubricant is very effective to make the lifetime longer. However, even with lubricant the lifetime is varied from about 1000 hours to almost 7000 hours in the past experiments. It is an important issue how the lubricant works on the lifetime of the system. In this paper the effect of lubricant on the degradation process of contact resistance is focused on. In the past tests the lubricant is supplied only once before the test. In this test the lubricant is regularly supplied almost every 900 operation hours. Consequently, the operation more than 8000 hours is realized, which is the longest among tests so far. In addition the contact voltage drop increase gradually until 2600 hours and after that it stays almost constant around 70 mV. According to the Element Analysis after the test the Ni base plating layer is totally exposed in many tracks. It means that the Au plating layer is gradually worn out probably at the stage of increasing voltage drop. In the previous tests the lifetime ended even when the Ni plating layer remained. So, the reason of long operation in this test is guessed to be that the lubricant not only decreases wear of ring and brush, but also suppresses oxidation of the Ni layer.

The design of microstrip bandpass filters using stepped-impedance resonators (SIRs) is examined. The passband center frequency for the WCDMA-FDD (uplink band) Japanese cellular system is 1950 MHz with a 60-MHz bandwidth. The SIR physical characteristic can be designed using a SIR characteristic chart based on second harmonic suppression. In our filter design, passband design charts were obtained through the design procedure. Tchebycheff and maximally flat bandpass filters of any bandwidth and any number of steps can be designed using these passband design charts. In addition, sharp skirt characteristics in the passband can be realized by having two transmission zeros at both adjacent frequency bands by using open-ended quarter-wavelength stubs at input and output ports. A new even-mode harmonics suppression technique is proposed to enable a wide rejection band having a high suppression level. The unloaded quality factor of the resonator used in the proposed filters is greater than 240.