We propose an architecture for a 1-bit band-pass delta-sigma modulator (BP-DSM) that outputs concurrent multiband RF signals. The proposed BP-DSM consists of parallel bandpass filters (BPFs) in the feedback loop to suppress the quantization noise at each target frequency band while maintaining the stability. Each BPF is based on second-order parallel infinite impulse response (IIR) filters. This architecture can unify and reconfigure the split BPFs according to the number of bands. The architecture complexity is proportional to the bandwidth of each RF signal and is independent of the carrier spacing between the bands. The conventional architecture of a concurrent multiband digital modulator, reported previously, has multiple input ports to the dedicated BPF at each band and so it cannot be efficiently integrated. Measurements show that the proposed architecture is feasible for transmitting a concurrent dual-band and a triple-band by changing the 1-bit digital data stream while keeping a data transmission rate of 10Gb/s. We demonstrate that the proposed architecture outputs the signal with LTE intra-band and inter-band carrier aggregation on 0.8GHz, 2.1GHz and 3.5GHz, each with 40MHz bandwidth in 120MHz aggregated bandwidth, whose bandwidth surpasses the bandwidth with carrier aggregation of LTE-A up to 100MHz. Adjacent channel leakage ratios of -49dBc and -46dBc are achieved at 3.5GHz in the concurrent dual-band and triple-band, respectively.

This paper proposes 1-bit feedforward distortion compensation for digital radio frequency conversion (DRFC) with 1-bit bandpass delta-sigma modulation (BP-DSM). The 1-bit BP-DSM allows direct RF signal transmission from a digitally modulated signal. However, it has been previously reported that 1-bit digital pulse trains with non-ideal rectangle waveform cause spectrum regrowth. The proposed architecture adds a feedforward path with another 1-bit BP-DSM and so can cancel out the distortion components at any target carrier frequency. Both the main signal and the distortion compensation signal are 1-bit digital pulse trains and so no additional analog RF circuit is required for distortion compensation. Simulation results show that the proposed method holds the adjacent channel leakage ratio to 60dB for LTE signal transmission. A prototype of the proposed 1-bit DRFC with an additional 1-bit BP-DSM in the feedforward path shows an ACLR of 50dB, 4dB higher than that of the conventional 1-bit DRFC.

The 1-bit band-pass delta-sigma modulator (BP-DSM) achieves high resolution if it uses an oversampling technique. This method can generate concurrent dual-band RF signals from a digitally modulated signal using a 1-bit digital pulse train. It was previously reported that the adjacent channel leakage ratio (ACLR) deteriorates owing to the asymmetrical waveform created by the pulse transition mismatch error of the rising and falling waveforms in the time domain and that the ACLR can be improved by distortion compensation. However, the reported distortion compensation method can only be performed for single-band transmission, and it fails to support multi-band transmission because the asymmetrical waveform compensated signal extends over a wide frequency range and is itself a harmful distortion outside the target band. Unfortunately, the increase of out-of-band power causes the BP-DSM unstable. We therefore propose a distortion compensator for a concurrent dual-band 1-bit BP-DSM that consists of a noise transfer function with a quasi-elliptic filter that can control the out-of-band gain frequency response against out-of-band oscillation. We demonstrate that dual-band LTE signals, each with 40MHz (2×20MHz) bandwidth, at 1.5 and 3.0GHz, can be compensated concurrently for spurious distortion under various combinations of rising and falling times and ACLR of up to 48dB, each with 120MHz bandwidth, including the double sided adjacent channels and next adjacent channels, is achieved.

The 1-bit digital radio frequency (DRF) transmitter using a band-pass delta-sigma modulator (BP-DSM) can output a radio frequency (RF) signal carrying a binary data stream with a constant data rate regardless of the carrier frequency, which makes it possible to transmit RF signals over digital optical links with a constant bit rate. However, the optical link requires a line coding, such as 8B10B or 64B66B, to constrain runlength and disparity, and the line coding corrupts the DRF power spectrum owing to additional or encoded data. This paper proposes a new line coding for BP-DSM, which is able to control the runlength and the disparity of the 1-bit data stream by adding a notch filter to the BP-DSM that suppresses the low frequency components. The notch filter stimulates the data change and balances the direct current (DC) components. It is demonstrated that the proposed line coding shortens the runlength from 50 bits to less than 8 bits and reduces the disparity from several thousand bits to 5 bits when the 1-bit DRF transmitter outputs an LTE signal with 5 MHz bandwidth, when using carrier frequencies from 0.5GHz to 2GHz and an output power variation of 60dB.

The 1-bit band-pass delta-sigma modulator (BP-DSM) achieves high resolution by using the oversampling technique. This method allows direct RF signal transmission from a digitally modulated signal, using a 1-bit digital pulse train. However, it has been previously reported that the adjacent channel leakage ratio (ACLR) in a target frequency band degrades due to the pulse transition mismatch between rising and falling waveforms in the time domain. This paper clarifies that the spurious distortion in BP-DSM is caused by the asymmetricity of the waveform about the center of an eye pattern in the time axis, and proposes a 1-bit BP-DSM with the compensator consisting of a fractional delay filter and a binary data differentiator to cancel out the asymmetry in the target frequency band. This can accurately provide a wideband cancellation signal with more than 100MHz bandwidth, including the adjacent channel, within 50dB power dynamic range. Using long term evolution (LTE) signals with 5MHz bandwidth at 0.8GHz, we simulated the spurious distortion, performing various combinations of rising and falling times in the eye pattern, and the proposed 1-bit BP-DSM always achieved high ACLR, up to 60dB, in 140MHz bandwidth, under all conditions.