1-5hit |
Shinsuke IBI Takumi TAKAHASHI Hisato IWAI
This paper proposes a novel differential active self-interference canceller (DASIC) algorithm for asynchronous in-band full-duplex (IBFD) Gaussian filtered frequency shift keying (GFSK), which is designed for wireless Internet of Things (IoT). In IBFD communications, where two terminals simultaneously transmit and receive signals in the same frequency band, there is an extremely strong self-interference (SI). The SI can be mitigated by an active SI canceller (ASIC), which subtracts an interference replica based on channel state information (CSI) from the received signal. The challenging problem is the realization of asynchronous IBFD for wireless IoT in indoor environments. In the asynchronous mode, pilot contamination is induced by the non-orthogonality between asynchronous pilot sequences. In addition, the transceiver suffers from analog front-end (AFE) impairments, such as phase noise. Due to these impairments, the SI cannot be canceled entirely at the receiver, resulting in residual interference. To address the above issue, the DASIC incorporates the principle of the differential codec, which enables to suppress SI without the CSI estimation of SI owing to the differential structure. Also, on the premise of using an error correction technique, iterative detection and decoding (IDD) is applied to improve the detection capability while exchanging the extrinsic log-likelihood ratio (LLR) between the maximum a-posteriori probability (MAP) detector and the channel decoder. Finally, the validity of using the DASIC algorithm is evaluated by computer simulations in terms of the packet error rate (PER). The results clearly demonstrate the possibility of realizing asynchronous IBFD.
Bluetooth is a common wireless technology that is widely used as a connection medium between various consumer electronic devices. The receivers mostly adopt the Viterbi algorithm to improve a bit error rate performance but are hampered by heavy hardware complexity and computational load due to a coherent detection and searching for the unknown modulation index. To address these challenges, a non-coherent maximum likelihood estimation detector with an eight-state Viterbi is proposed for Gaussian frequency-shift keying symbol detection against an irrational modulation index, without any knowledge of prior information or assumptions. The simulation results showed an improvement in the performance compared to other ideal approaches.
An entire dual-mode transceiver capable of both the conventional GFSK-modulated Bluetooth and the Medium-Rate π/4-DQPSK-modulated Bluetooth has been investigated and reported. The transmitter introduces a novel two-point-modulated polar-loop technique without the global feedback to realize reduced power consumption, small chip area and also high modulation accuracy. The receiver shares all the circuits for both operating modes except the demodulators and also features a newly-proposed cancellation technique of the carrier-frequency offset. The transceiver has been confirmed by system or circuit simulations to meet all the dual-mode Bluetooth specifications. The simulation results show that the transmitting power can be larger than 10 dBm while achieving the total power efficiency above 30% and also RMS DEVM of 0.050. It was also confirmed by simulation that the receiver is expected to attain the sensitivity of -85 dBm in both modes while satisfying the image-rejection and the blocker-suppression specifications. The proposed transceiver will provide a low-cost, low-power single-chip RF-IC solution for the next-generation Bluetooth communication.
Toru TANZAWA Kenichi AGAWA Hiroyuki SHIBAYAMA Ryota TERAUCHI Katsumi HISANO Hiroki ISHIKURO Shouhei KOUSAI Hiroyuki KOBAYASHI Hideaki MAJIMA Toru TAKAYAMA Masayuki KOIZUMI Fumitoshi HATORI
A frequency drift of open-loop PLL is an issue for the direct-modulation applications such as Bluetooth transceiver. The drift mainly comes from a temperature variation of VCO during the transmission operation. In this paper, we propose the optimum location of the VCO, considering the temperature gradient through the whole-chip thermal analysis. Moreover, a novel temperature-compensated VCO, employing a new biasing scheme, is proposed. The combination of these two techniques enables the power reduction of the transmitter by 33% without sacrificing the performance.
A digital noncoherent demodulation scheme is presented for reception of Gaussian frequency shift keying (GFSK) signals with small modulation index. The proposed differential demodulator utilizes oversampled signals to estimate the symbol timing and to compensate the frequency offset. The performance of the proposed receiver is evaluated in terms of the bit-error rate (BER). Numerical results show that the proposed demodulator provides performance comparable to that of conventional baseband differential demodulator, while significantly reducing the implementation complexity suitable for single chip integration with direct conversion radio frequency module. Finally the performance of the proposed receiver is improved by adding a simple decision feedback module.