Simultaneous all-optical frequency up/downconversion technique utilizing a single semiconductor optical amplifier Mach-Zehnder interferometer (SOA-MZI) for full-duplex WDM radio over fiber (RoF) applications is presented. Using this technique, error-free simultaneous upconversion and downconversion of RoF signals with a finite-length single mode fiber were experimentally demonstrated. The results show the potential of the proposed scheme for use in a cost-effective full-duplex WDM RoF link.

Undersampling (or bandpass sampling) phase modulated signals directly at high frequency band, the harmful effects of the aperture jitter characteristics of ADCs (Analog-to-Digital converters) and sampling clock instability of the system can not be ignored. In communication systems the sampling jitter brings additional phase noise to the constellation pattern besides thermal noise, thus the BER (bit error rate) performance will be degraded. This paper examines the relationship between the input frequency to ADC and the sampling jitter in digital IF (Intermediate Frequency) downconversion receivers with undersampling scheme. This paper presents the measurement results with a real hardware prototype system as well as the computer simulation results with a theoretically modeled IF sampling receiver. We evaluated EVM (Error Vector Magnitude) in various clock jitter configurations with commonly used and reasonable cost ADCs of which sampling rates was 40 MHz. According to the results, the IF input frequencies of QPSK (16 QAM) signals were limited below around 290 (210) MHz for wireless LAN standard, and 730 (450) MHz for W-CDMA standard, respectively, in our best configuration.

Full-duplex transmission of 60.0 GHz and 59.6 GHz millimeter-wave (mm-wave) signals of 155.52-Mbit/s differential phase shift keying (DPSK) data, radio-on-fiber (ROF) signals over 25-km-long standard single-mode fibers (SMFs) is experimentally demonstrated for the first time using a single 2-RF-port electroabsorption transceiver (EAT). The simplification of base stations (BSs) is strongly required to realize cost-effective and high-reliability mm-wave wireless access. This single EAT detects a C-band ROF signal modulated by a mm-wave downlink signal and simultaneously modulates the L-band optical carrier by a mm-wave uplink signal. The BS mainly consists of the EAT, leading to a simple and low-cost BS. Optical pilot tones and optical bandpass filters are used for photonic downconversion and photonic upconversion, to convert frequencies between mm-wave signals and intermediate frequency (IF) signals in the optical domain. With the use of optical conversions, these signals have no significant fading problems. The simultaneous transmission of both up- and downlinks has been achieved with the BER of less than 10-9. Also the fading problems due to the fiber dispersion of photonic conversions are analyzed mathematically in this paper. The single-EAT BS will become a promising candidate for a ROF access system.