To achieve high end-to-end availability in nationwide optical transport network across thousands of office buildings, it is important to properly make each function redundant, and execute protection switching, repair failed functions and recover redundancy to prevent multiple simultaneous failures. High redundancy leads to high system cost and high power consumption, and tight conditions for recovery leads to high maintenance cost. Therefore it is important to optimize the balance between redundancy and maintenance condition based on appropriate availability indicators. We previously proposed a resource-pool control mechanism for a nationwide optical transport network that can optimize the balance. This paper proposes an end-to-end availability evaluation scheme for a nationwide optical transport network with our mechanism, by which network operators can design the pool-resource amount of each function and the maintenance conditions for each network area properly to satisfy the end-to-end availability requirement. Although the maintenance conditions are usually discussed based on failure-recovery times, they should be discussed based on cost- or load-based volumes for this design. This paper proposes a maintenance-operation-load evaluation scheme, which derives the required number of maintenance staff members from failure-recovery times. We also discuss the design of the pool-resource amount and maintenance conditions for each network area of a nationwide network based on the proposed evaluation schemes.

This paper proposes a regulated transport network design algorithm for IP over a dense wavelength division multiplex (DWDM) network. When designing an IP over DWDM network, the network operator should consider not only cost-effectiveness and physical constraints such as wavelength colors and chromatic dispersion but also operational policies such as resilience, quality, stability, and operability. For considering the above polices, we propose to separate the network design algorithm based on a geographical resolution; the policy-based regulated intra-area is designed based on this resolution, and the cost-optimal inter-area is then designed separately, and finally merged. This approach does not necessarily yield a strict optimal solution, but it covers network design work done by humans, which takes a vast amount of time and requires a high skill level. For efficient geographical resolution, we also present fast graph mining algorithm, which can solve NP-hard subgraph isomorphism problem within the practical time. We prove the sufficiency of the resulting network design for the above polices by visualizing the topology, and also prove that the penalty of applying the approach is trivial.

An optical transport network is composed of optical transport systems deployed in thousands of office-buildings. As a common infrastructure to accommodate diversified communication services with drastic traffic growth, it is necessary not only to continuously convey the growing traffic but also to achieve high end-to-end communication quality and availability and provide flexible controllability in cooperation with service layer networks. To achieve high-speed and large-capacity transport systems cost-effectively, system configuration, applied devices, and the manufacturing process have recently begun to change, and the cause of failure or performance degradation has become more complex and diversified. The drastic traffic growth and pattern change of service networks increase the frequency and scale of transport-capacity increase and transport-network reconfiguration in cooperation with service networks. Therefore, drastic traffic growth affects both optical-transport-system configuration and its operational cycles. In this paper, we give an overview of the operational problems emerging in current nationwide optical transport networks, and based on trends analysis for system configuration and network-control schemes, we propose a vision of the future nationwide optical-transport-network architecture expressed using five target features.

Software defined networking (SDN) and OpenFlow, which enables the abstraction of vendor/technology-specific attributes, improve the control and management flexibility of optical transport networks. In this paper, we present an interoperability demonstration of SDN/OpenFlow-based optical path control for multi-domain/multi-technology optical transport networks. We also summarize the abstraction approaches proposed for multi-technology network integration at SDN controllers.

We propose and experimentally demonstrate a simple method for monitoring optical signal-to-noise ratio. The novel method can be used in the optical transport networks using optical cross-connects or reconfigurable optical add-drop multiplexers. OSNR is measured by monitoring the transmitted optical power and the reflected optical power from fiber Bragg grating. We have obtained OSNR with an error less than 0.8 dB.

In this paper, we propose a novel architecture for optical transport networks and its operation scheme guaranteeing the QoS requirements based on real-time traffic measurement. The key concept of the proposed architecture, which we call hybrid optical transport network (HOTNET), is to adopt both optical circuit switching and optical message switching in an optical network. To implement two different switching technologies in a single network, we modify the optical burst switching scheme and merge it into a TDM wavelength routed network. Then, we propose a control framework and an architecture of a switching node for this hybrid switching paradigm. We also discuss a real-time bandwidth provisioning scheme which utilizes the advantages of two respective switching schemes for traffic engineering. Finally, we evaluate the performance of the proposed scheme via computer simulation and the results show that it can guarantee the traffic QoS requirements while maintaining high channel utilization.

This paper discusses global area optical transport ring networks using wavelength division multiplexing (WDM) technologies and proposes a novel optical add/drop multiplexer (OADM) architecture suitable for such an application field. Study on the requirements of a global area ring application elucidates the appropriate ring/protection architecture as the path switched bi-directional ring. The proposed OADM architecture has flexibility in terms of path provisioning and scalability. We conclude that the proposed OADM can effectively configure the large-scale path switched bi-directional rings.

This paper discusses global area optical transport ring networks using wavelength division multiplexing (WDM) technologies and proposes a novel optical add/drop multiplexer (OADM) architecture suitable for such an application field. Study on the requirements of a global area ring application elucidates the appropriate ring/protection architecture as the path switched bi-directional ring. The proposed OADM architecture has flexibility in terms of path provisioning and scalability. We conclude that the proposed OADM can effectively configure the large-scale path switched bi-directional rings.