This paper presents a clock routing technique called Balanced-Mesh Method (BMM) which incorporates the advantages of two famous conventional-clock-routing techniques. One is the balanced-tree method (BTM) where the clock net is routed as a tree so that the delay times of clock signal are balanced, and the other is the fixed-mesh method (FMM) where the clock net is routed as a fixed mesh driven by a large buffer. In BMM, the clock net is routed as a set of relatively small meshes of interconnects driven by relatively small buffers. Each mesh covers an area called a Mesh-Routing Region (MR) in which its delay and skew can be suppressed within a certain range. These small meshes are connected by a balanced tree with the chip clock source as its root. To implement BMM, we developed an MR-partitioning program that partitions the circuit into MR's according to a set of pre-determined constraints on the number of flip-flops and the area in each MR, and a clock-global-routing program that provides each mesh routing and the tree routing connecting meshes. We applied BMM to the design of an MPEG2-encoder LSI and achieved a skew of 210ps. In addition, the experimental results show BMM yields the lowest power dissipation compared to conventional methods.

In this paper, a post-layout optimization technique for power dissipation and timing of cell-based Bipolar ECL LSIs is proposed. An ECL LSI can operate at a frequency of a few GHz but the power dissipation is very high compared to CMOS LSIs, which makes the systems using ECL quite expensive. Therefore it is crucial to develop of CAD techniques that minimize the power dissipation of an ECL LSI without decreasing its performance. To begin with, power and delay models of an ECL gate are presented as functions of its switching current. The power dissipation is a linear function of the switching current and the delay time is its hyperbolic function. These functions are obtained considering the post-layout interconnect capacitance and resistance to make the optimization results accurate enough. Using the delay model, a set of timing constraints specifying the max/min cell delay and the clock skew are extracted. This set of constraints in then given to a nonlinear programming package. The objective functions are clock skew time, the clock cycle time and the power dissipation, which are optimized in this order. With the minimum delay and hold constraints, the problem is not convex so that conventional convex programming approach cannot be used. As a result of the optimization, the switching currents for cells are obtained. These are realized within cells by regulating programmable resistors", which is a special feature of our ECL cell library. Since the above optimization is carried out after the placement and routing of the circuit, it can take accurate delay and power estimation into consideration. Experimental results show more than 40% power reductions for circuits including a real communication system chip, compared to the max power versions. The clock cycle time was maintained or even made faster due to the efficient clock skew optimization.

A computer-aided low-power design methodology for very high-speed Si bipolar standard cell LSI is described. In order to obtain Gbit/s-speed operation, it features a pair of differential clock channels inside cells and a highly accurate static timing analysis for back annotation. A newly developed CAD-based power optimization scheme minimizes cell currents while maintaining circuit speed. A 5.6 k gate SDH signal-processing LSI operating at 1.6 Gbit/s with only 3.9 W power consumption demonstrates the effectiveness of this design technology.