Two kinds of composite right/left-handed coaxial lines (CRLH CLs) are designed for an antenna element. The dispersion relations of the infinite periodic CRLH CLs are designed to occur -1st resonance at around 700 MHz, respectively. The designed CRLH CLs comprise a monopole and a choke structure for antenna elements. To verify the resonant modes and frequencies, the monopole structure, the choke structure, and the antenna element which is combined the monopole and the choke structures are simulated by eigenmode analysis. The resonant frequencies correspond to the dispersion relations. The monopole and the choke structures are applied to the coaxially fed antenna. The proposed antenna matches at 710 MHz and radiates. At the resonant frequency, the total length of the proposed antenna which is the length of the monopole structure plus the choke structure is 0.12 wavelength. The characteristics of the proposed antenna has been compared with that of the conventional coaxially fed monopole antenna without the choke structure and the sleeve antenna with the quarter-wavelength choke structure. The radiation pattern of the proposed antenna is omnidirectional, the total antenna efficiency is 0.73 at resonant frequencies, and leakage current is suppressed lesser than -10 dB at resonant frequency. The propose antenna is fabricated and measured. The measured |S11| characteristics, radiation patterns, and the total antenna efficiency are in good agreement with the simulated results.

Novel design approaches for microwave active circuits using composite right-/left-handed (CRLH) transmission line (TL) stubs are presented. We show that, by modifying the dispersion diagram of the CRLH TL stub, the frequency band or the harmonic tuning capability can be enhanced in such a way that it would have been difficult or impractical if done using conventional micro-strip line stubs. The frequency response of the CRLH TL stub can be controlled almost arbitrarily while at the same time reducing the stub length significantly, because the dispersion curve in the left-handed region and in the right-handed region is controlled independently. As a proof of concept, a triple-band rectifier, single-band and dual-band harmonic tuning circuits for class-F amplifiers are demonstrated.

A compact composite right/left-handed transmission-line (CRLH TL) stub resonator is presented. The bandpass frequency of the resonator and the adjacent transmission-zeros are determined by the negative order resonance modes of the stub line. We demonstrate that these resonance frequencies can be arbitrarily controlled by using non-identical, unbalanced unit cells, leading to enhanced loaded-Q as well as unloaded-Q. We show that despite the presence of lumped element loss the unloaded-Q is enhanced by a factor of 2 compared to that of microstrip line as a result of nearly-zero group velocity. As a consequence, the loaded-Q can be increased without incurring significant insertion loss as in the case of conventional stub resonators on the same substrate. The physical mechanisms of the distinct features are discussed based on an equivalent dispersion diagram, a concept introduced to model general one-port CRLH TL used as a stub line.

In this paper, we consider a parallel ring-line rat-race circuit realized by replacing some parts of the ring-lines with composite right-/left-handed transmission lines (CRLH-TLs). For a conventional rat-race circuit, the minimum coupling factor is limited by the highest impedance of the ring-lines that can be manufactured by general printed circuit board (PCB) technologies. However, the coupling factor of the parallel ring-line type rat-race circuit proposed in this paper is determined by the difference between the admittances of the parallel ring-lines. As a result of designing parallel ring-line rat-race circuits having coupling factors of $-20$ and $-30$,dB for an operation frequency of 4,GHz, the proposed rat-race circuit realizes broadband characteristics of about 35.5% according to the numerical results for the $-20$,dB circuit. Furthermore, broadband characteristics including reflection, isolation, and couplings can be maintained for the fabricated $-20$,dB rat-race circuit up to an input power of 40,dBm.

A design of dual band amplifier using composite right/left handed (CRLH) transmission line structure is described. First, two single-band matching networks are designed for two frequencies, and they are synthesized into one dual band matching network. It is shown that CRLH transmission lines with arbitrary dual frequencies and dual electrical lengths can be designed. The CRLH transmission line section for the dual band matching network is implemented by lumped inductors and capacitors as the left handed (LH) section, and normal transmission line elements as the right handed (RH) section. As an example, a dual band amplifier for 1800 MHz and 2300 MHz is designed and measured. The simulated and measured performances well verify the proposed design by showing good matching and gain responses at the desired frequencies.

A composite right/left-handed transmission line (CRLH-TL) using substrate integrated waveguide (SIW) with floating-conductor (SIW-type CRLH-TL) for microwave and millimeter wave frequencies has been proposed by the authors. This paper proposes a new configuration that is shield type of the SIW-type CRLH-TL, which can suppress the radiation from the exposed floating-conductors, and shows that even if the shielded structure is used, the SIW-type CRLH-TL supports the LH mode as well as the prototype. Proposed CRLH-TL consists of a SIW with slot apertures (part 1), a dielectric film with floating-conductors (part 2) and a SIW without lower conductor (part 3). A shielded SIW-type CRLH-TL for X--K band (with wide LH mode bandwidth of 6 GHz and transition frequency of 16 GHz) that satisfies the balance condition is designed. Dispersion diagram and S-parameters are derived numerically, and typical field distributions of RH and LH transmission and the zeroth-order resonance are shown. Measured result agrees well with theoretical result, by considering the accuracy performance and loss factors of the fabricated CRLH-TL. Proposed CRLH-TL has advantage of simple manufacturing, because the parts 1--3 are composed of simple planar periodic structure. It is expected to be one of the basic structure of CRLH-TL or components such as LH coupler above 10 GHz or millimeter wave frequency.

In this paper, a resonator based on composite right/left handed transmission line concept is discussed. This resonator excites --1st order resonance mode. We start with half-wave resonators consisting of two unit cells of a composite right/left handed transmission line. From the simulated field distributions, the center of these half-wave resonators can be short-circuited to obtain a quarter-wave resonator in the --1st mode. Susceptance slope parameters are calculated for the resonator. Then this resonator is applied for a 2-pole filter made by LTCC, which can be designed with standard filter design theory owing to the slope parameter. The dimension of the experimental filter implemented by LTCC is 2.5 mm by 1.35 mm by 0.52 mm. The insertion loss is 1.80 dB at the 2.4 GHz band. Good agreement between measured and computed results is obtained.

This paper treats a band-broadening design technique of a dual-band branch-line coupler with matching networks composed of an impedance step and a short-circuited stub based on the equivalent admittance approach. By replacing each right-handed transmission line (RH-TL) with a composite right/left-handed transmission line (CRLH-TL), very flat couplings over a relative bandwidth of about 10% can be obtained at two arbitrary operating frequencies in comparison with previous CRLH-TLs branch-line couplers. Furthermore, by adding periodical open-circuited stubs into RH-TLs of the designed CRLH-TLs branch-line coupler with matching networks, the entire size of the coupler can be reduced to about 50%. Verification of these band-broadening and size-reduction design techniques can be also shown by an electromagnetic simulation and experiment.

A composite right/left-handed (CRLH) transmission line with demultiplexing property is proposed towards short-range functional wireless interconnects. The CRLH line is designed by analyzing dispersion relation of the microstrip line having a split-ring and a double-stub structure to realize frequency selective properties for leaky wave radiation. A prototype device is fabricated and estimated to study feasibility of the demultiplexing operation around ten GHz.

A dispersion diagram is useful in interpreting the characteristics of a periodic structure. In particular, the fast-wave region, where the wave is radiating, and the slow-wave region, where the wave is guided, can be determined from the dispersion diagram. An electronically-controlled composite right/left-handed (CRLH) transmission line (TL) was previously proposed and utilized as a leaky-wave (LW) antenna operating in the fast-wave region. However, since a guided-wave application operates in the slow-wave region, it is meaningful to study slow-wave effects of the proposed TL. In this paper, the dispersion diagram is used to investigate the slow-wave factor (SWF), which is necessary to understand the fast/slow-wave operations. Furthermore, the frequency characteristics are measured to find the cut-off frequencies in the LH and RH regions. Based on experimental results, it is observed at a fixed frequency, 2.6-GHz, that the phase of a proposed 6-cell structure can be changed by up to 280 in the LH slow-wave region.

We propose here a composite right/left handed transmission line constructed by using conductor-backed coplanar strips. In this line, we can easily realize a shunt inductor without via because it has the electric-wall symmetry at the guide center. The left-handed nature is verified by both the finite difference time-domain (FDTD) and the equivalent-circuit calculations. Furthermore, we demonstrate the proposed line can easily satisfy the balanced condition for no band gap between the right-handed and the left-handed modes, and can be applied to a leaky-wave antenna, numerically and experimentally.

A novel planar composite right/left handed (CRLH) transmission line (TL) with double-sided metal patterns, which is advantageous in high scalability and low-cost fabrication, is proposed. Fundamental characteristics of the unbalanced and balanced CRLH TLs are confirmed numerically and theoretically both by full-wave finite-element method (FEM) simulations and the equivalent circuit analysis in terms of dispersion characteristics and characteristic impedances for the periodic structure. It is also shown that the relations between the left-handed circuit parameters and the geometrical parameters of the unit cell are simple and intuitive, which is useful for designing the CRLH TL. Experiments on 10-cell unbalanced and balanced CRLH TLs are carried out and the left-handed and right-handed wave propagations are confirmed by scattering parameter and near field measurements.