When a cognitive radio system dynamically utilizes a frequency band, channel control information must be communicated over the network in order for the currently available carrier frequencies to be shared. In order to keep efficient spectrum utilization, this control information should also be dynamically transmitted through channels such as cognitive pilot channels based on the channel conditions. If transmitters dynamically select carrier frequencies, receivers must receive the control signal without knowledge of its carrier frequencies. A novel scheme called differential code parallel transmission (DCPT) enables receivers to receive low-rate information without any knowledge of the carrier frequency. The transmitter simultaneously transmits two signals whose carrier frequencies are separated by a predefined value. The absolute values of the carrier frequencies can be varied. When the receiver receives the DCPT signal, it multiplies the signal by a frequency-shifted version of itself; this yields a DC component that represents the data signal, which is then demodulated. However, the multiplication process results in the noise power being squared, necessitating high received signal power. In this paper, to realize a bandpass filter that passes only DCPT signals of unknown frequency and that suppresses noise and interference at other frequencies, a DCPT-adaptive bandpass filter (ABF) that employs an adaptive equalizer is proposed. In the training phase, the received signal is the filter input and the frequency-shifted signal is the training input. Then, the filter is trained to pass the higher-frequency signal of the two DCPT signals. The performance of DCPT-ABF is evaluated through computer simulations. We find that DCPT-ABF operates successfully even under strong interference.

A new compact line equalizer is proposed for backplane serial link applications. The equalizer has two control blocks. The feed-forward swing control block determines the optimal low frequency level and the feedback control block detects signal shapes and decides the high-frequency boosting level of the equalizer. Successful equalization is demonstrated over a 1.5 m long PCB trace at 3.125-Gb/s by the circuit realized with 0.18 µm CMOS process. The circuit occupies only 0.16 mm2 and consumes 20 mW with 1.8 V supply.

The cable length in wired serial data communication is limited because the limited bandwidth of a long cable introduces ISI (Inter Symbol Interference). A line equalizer can be used at the receiver to extend the channel bandwidth. This paper proposes a low-power and small-area analog adaptive line equalizer for 100-Mb/s operation on UTP (Unshielded Twisted Pair) cable up to 100 m. The proposed adaptive line equalizer is fabricated with 0.35-µm CMOS process, consumes 19 mW and occupies only 0.07 mm2 Measurement results show that the prototype can operate at data rate of 100 Mb/s on a 100-m cable and 155 Mb/s on a 50-m cable.

A blind equalizer which uses the differential constant modulus algorithm (DCMA) is introduced. An anchored FIR equalizer applied to a first-order autoregressive channel and updated according to the DCMA is shown to converge to the inverse of that channel regardless of the initial tap-weights and the gain along the direct path.

This paper proposes list Viterbi equalizers (LVEs) that use two kinds of metric criteria for wide-spread time-dispersive channels to achieve a good trade-off between complexity and bit error rate (BER) performance. For Viterbi equalization employing a state-reduction algorithm, the modified metric criterion proposed by Ungerboeck is not always equivalent to the squared Euclidean distance metric criterion. This paper proposes the following two schemes for the LVE: (1) to combine two kinds of metric criteria like combining diversity; (2) to select the metric criterion like selection diversity according to the channel impulse response. Finally, computer simulation shows that the proposed schemes improve BER performance on wide-spread frequency selective fading channels, even if the proposed schemes have smaller complexity than the conventional one.

A signal suffers from nonlinear, linear, and additive distortion when transmitted through a channel. Linear equalizers are commonly used in receivers to compensate for linear channel distortion. As an alternative, novel equalizer structures utilizing neural computation have been developed for compensating for nonlinear channel distortion. In this paper, we propose a neural detector based on self-organizing map (SOM) in a 16 QAM system. The proposed scheme uses the SOM algorithm and symbol-by-symbol detector to form a neural detector, and it adapts well to the changing channel conditions, including nonlinear distortions because of the topology-preserving property of the SOM algorithm. According to the theoretical analysis and computer simulation results, the proposed scheme is shown to have better performance than traditional linear equalizer when facing with nonlinear distortion.

This paper proposes a beam and null simultaneous steering Space-Time Equalizer (S/T-Equalizer). The proposed S/T-Equalizer performs separated S/T-signal processing in order to reduce computational complexity to a practical level. For spatial signal processing, a new Adaptive Array Antenna algorithm is used that combines the beam and null steering concepts. For temporal signal processing, a conventional delayed decision feedback sequence estimation equalizer may be used. The proposed S/T-Equalizer was prototyped, and a series of field tests was conducted using a 5 GHz frequency band to evaluate transmission performances of the proposed system. Results show that the proposed S/T-Equalizer can reduce inter-symbol interference effects while maintaining reasonable signal strength, thereby improving BER performance.

Providing results of a series of link-level simulations for a class of spatial and temporal equalizer (S/T-equalizer) is the primary objective of this letter, which is supplemental to this letter's companion article. The S/T-equalizers discussed in this letter have a configuration that can be expressed as the cascaded connection of adaptive array antenna and maximum likelihood sequence estimator (MLSE): each of the adaptive array antenna elements has a fractionally spaced tapped delay line (FTDL), and the MLSE has taps covering a portion of the channel delay profile. Both the desired and interference signals suffer from severe inter-symbol interference (ISI). A major difference of this article from its companion letter is that account is taken of the presence of co-channel interference (CCI). Bit error rate (BER) performance of the S/T-equalizer is presented as a result of the link-level simulations that use field measurement data.

This letter shows the results of a series of link level simulations conducted to evaluate the performances of spatial and temporal equalizers (S/T-equalizers) using field measurement data. The configuration of the spatial and temporal equalizer discussed in this letter can be expressed as a cascade of an adaptive array antenna and maximum likelihood sequence estimator (MLSE): each of the adaptive array antenna elements has a fractionally spaced tapped delay line (FTDL), and the MLSE has taps covering a portion of channel delay profile. Bit error rate (BER) performances of the S/T-equalizers are presented, and performance sensitivity to symbol timing offset is investigated.

This paper proposes a survivor-correction Viterbi algorithm (SCVA) and presents its application to an iterative sequence estimation in order to improve bit error rate performance of decision-feedback sequence estimation (DFSE) in the presence of intersymbol interference. The SCVA can mitigate erroneous survivor selections due to DFSE, because it modifies the add-compare-select operation to an add-correct-compare-select operation. Finally, it is confirmed by computer simulation that complexity of the proposed scheme is independent of delay of the main delayed ray and its performance is superior to that of DFSE at the same number of states.

This paper proposes an adaptive list-output Viterbi equalizer (LVE) with fast compare-select operation, in order to achieve a good trade-off between bit error rate (BER) performance and processing speed. An LVE, which keeps several survivors for each state, has good BER performance in the presence of wide-spread intersymbol interference. However, the LVE suffers from large processing delay due to its sorting-based compare-select operation. The proposed adaptive LVE greatly reduces its processing delay, because it simplifies compare-select operation. In addition, computer simulation shows that the proposed LVE causes only slight BER performance degradation due to its simplification of compare-select operation. Thus, the proposed LVE achieves better BER performance than decision-feedback sequence estimation (DFSE) without an increase in processing delay.

This paper proposes a phase-rotating phase-shift keying (PSK) modulation and shows that its narrow-band version is suitable for Viterbi equalization. The proposed PSK has the following features: 1) a spectrum shaping of the transmit/receive filters does not need to be restricted to the Nyquist criterion; 2) the transmitted data sequence is rotated for every symbol in order to reduce noise-correlation at the receiver. First, this paper discusses a performance degradation of bit error rate of Viterbi equalizers in the presence of the sampling timing offset or under time-dispersive frequency selective fading. Next, computer simulation confirms that π/2-shifted binary PSK with narrow-band spectrum shaping filter, which includes offset QPSK for its special case, solves the above mentioned performance degradation, keeping good spectrum efficiency equal to M-ary PSK.

This paper describes methods used in the design of a high speed burst modem applied for mobile communication systems. The modem has burst mode operations including burst mode AGC (automatic gain control), burst mode BTR (bit timing recovery), adaptive equalization, and diversity based on a selection algorithm to achieve a higher performance in multipath fading channels. Moreover, the performance of the burst modem, which is developed using analog signal processing devices, DSPs (digital signal processors), and FPGAs (field programmable gate arrays), is analyzed experimentally. Results show that the modem can suppress irreducible BER values below 1. 0e-6 and attains a 2 dB implicit diversity gain over multipath fading channels modeled by a two-ray impulse response system with independent Rayleigh fading.

This paper proposes an integrated interference suppression scheme which realizes interference-resistant satellite digital signal transmission systems. It employs a notch filter in the receiving side to suppress the co-channel interference (CCI) signal. Moreover, the proposed scheme employs an adaptive equalizer combined with a forward error correction (FEC) scheme to improve the Pe (probability of error) performance degradation due to the inter-symbol interference caused by notch filtering of the desired signal. In the typical frequency modulation (FM) CCI environment with a BWi/FN of 2.3 (BWi: interference signal required bandwidth, fN: one half the Nyquist bandwidth of the desired signal), a Δf / fN of 1.05 (Δf: interference frequency offset) and a D/U of 3 dB (desired to undesired (interference) signal power ratio), the proposed scheme improves the required Eb/NO by 1.5 dB at a Pe of 10-4 compared to that without an adaptive equalizer.

This paper presents a structure of adaptive equalizer equipped with a neural network and a Viterbi decoder, and evaluates its performance under a fading environment by means of computer simulation.

A receiving system suitable for multipath fading channels with co-channel interference is described. This system is equipped with both an M-sectored directional antenna and an adaptive equalizer to mitigate the influence due to multipath propagation and co-channel interference. By using directional antennas, this receiving system can separate desirable signals from undesirable signals, such as multipath signals with longer delay time and co-channel interference. It accepts multipath signals which can be equalized by maximum likelihood sequence estimation, and rejects both multipath signals with longer delay time and co-channel interference. Based on computer simulation results, the performance of the proposed receiving system is analyzed assuming simple propagation models with Rayleigh-distributed multipath signals and co-channel interference.

This paper proposes and investigates an adaptive equalizer with diversity-combining over a multipath fading channel. It consists of two space-diversity antennas and a Ts/2-spaced decision-feedback-equalizer (DFE). Received signals from the two antennas are alternatively switched and fed into the feed forward-filter of DFE. We call this structure a Switched Input Combining Equalizer with diversity-combining (SICE). By using an SICE, the receiver structure for combining diversity equalization can be simplified, because it needs only two receiver sections up to IF BPF. The bit error rate (BER) performance of SICE was evaluated by both computer simulation and experiment over a multipath fading channel. We experimentally confirmed the excellent BER performance, around 1% of BER over a multipath fading channel at 160Hz of maximum doppler fading frequency. Therefore, the proposed SICE is applicable to highly reliable transmission in the 1.5-GHz-band mobile radio.