This paper proposes an ultra-low-voltage, wide signal swing, and clock-scalable differential dynamic amplifier using a common-mode voltage detection technique. The essential characteristics of an amplifier, such as gain, linearity, power consumption, noise, etc., are analyzed. In measurement, the proposed dynamic amplifier achieves a 13dB gain with less than 1dB drop over a differential output signal swing of 340mVpp with a supply voltage of 0.5V. The attained maximum operating frequency is 700MHz. With a 0.7V supply, the gain increases to 16dB with a signal swing of 700mVpp. The prototype amplifier is fabricated in 90nm CMOS technology with the low threshold voltage and the deep N-well options.

This paper analyzes a pseudo-differential dynamic comparator with a dynamic pre-amplifier. The transient gain of a dynamic pre-amplifier is derived and applied to equations of the thermal noise and the regeneration time of a comparator. This analysis enhances understanding of the roles of transistor's parameters in pre-amplifier's gain. Based on the calculated gain, two calibration methods are also analyzed. One is calibration of a load capacitance and the other is calibration of a bypass current. The analysis helps designers' estimation for the accuracy of calibration, dead-zone of a comparator with a calibration circuit, and the influence of PVT variation. The analyzed comparator uses 90-nm CMOS technology as an example and each estimation is compared with simulation results.