This paper proposes a novel configuration for a wideband single-carrier transmitter using a sub-terahertz frequency. For wideband single-carrier transmission over a bandwidth of several gigahertz, the frequency response non-flatness derived from transmitter components in an operating band seriously deteriorates the transmission quality due to inter-symbol interference. A promising approach to address this problem is equalizing the frequency response non-flatness at the transmitter. The proposed novel configuration has a feedback route for calculating the inverse frequency response and multiplying it with a transmission signal spectrum in the frequency domain. Moreover, we verify that employing the proposed transmitter configuration simplifies the receiver configuration by lowering the calculation complexity to minimize the inter-symbol interference to meet the signal-to-interference-and-noise ratio requirements. To confirm the feasibility of the proposed configuration, the transmission quality obtained using the proposed configuration is measured and evaluated. Experimental results confirm that the proposed configuration improves the error vector magnitude value to over 5 dB for a 10 Gbaud transmission and the transmission data rate of 25 Gbps.

This paper presents a novel isolator that employs a varactor that tunes the operating frequency for use in future multi-band mobile handsets. The proposed isolator employs only one varactor for compactness and has a three-fold symmetric structure to reduce the parasitic reactance at each port. Analytical and experimental results clarify the tuning range of the proposed isolator. This paper presents the fundamental characteristics of the proposed isolator such as the insertion loss, isolation, and adjacent channel leakage ratio (ACLR) using a W-CDMA signal. The impact of the proposed isolator on the system performance is described based on experimental evaluation of the ACLR with a multi-band transmission system consisting of a power amplifier and the proposed isolator.

This paper presents a highly efficient multi-band power amplifier (PA) with a novel reconfigurable configuration. It consists of band-switchable matching networks (BS-MNs) and a biasing network (BS-BN) that are available for multi-band operation. BS-MNs with a susceptance block (SB) require a shorter transmission line (TL) than those without the SB at some target impedances. This paper theoretically derives the relationships of the required TL lengths for the BS-MN with or without the SB and the target impedances. The required TL lengths at the target impedances are evaluated numerically in order to discuss the advantages of the proposed configuration. The BS-BN employing switches for band switching can supply DC power to an amplification device without additional DC power dissipation because the DC bias current does not flow through the switches. Numerical analyses confirm that a BS-BN can be configured with low loss in multiple bands. Based on the proposed configuration, a 1/1.5/1.9/2.5-GHz quad-band reconfigurable PA is designed and fabricated employing RF microelectro mechanical systems switches and partitioned low temperature co-fired ceramics substrates. The fabricated 1 W-class PA achieves a high output power of greater than 30 dBm and a maximum power added efficiency of over 40% in all operating modes.

This paper presents a novel design scheme for a band-switchable multi-band power amplifier (BS-MPA). A key point of the design scheme is configuring multi-section reconfigurable matching networks (MR-MNs) optimally in terms of low loss matching in multiple frequency bands from 0.7 to 2.5 GHz. The MR-MN consists of several matching sections, each of which has a matching block connected to a transmission line via a switch. Power dissipation at an actual on-state switch results in the insertion loss of the MR-MN and depends on how the impedance is transformed by the MR-MN. The proposed design scheme appropriately transforms the impedance of a high power transistor to configure a low loss MR-MN. Numerical analyses show quantitative improvement in the loss using the proposed scheme. A 9-band 3-stage BS-MPA is newly designed following the proposed scheme and fabricated on a multi-layer low temperature co-fired ceramic substrate for compactness. The BS-MPA achieves a gain of over 30 dB, an output power of greater than 33 dBm and a power added efficiency of over 40% at the supply voltage of 4 V in each operating band.

A novel scheme for a multi-band power amplifier (PA) that employs a low-loss reconfigurable matching network is presented and discussed. The matching network basically consists of a cascade of single-stub tuning circuits, in which each stub is connected to a transmission line via a Single-Pole-Single-Throw (SPST) switch. By controlling the on/off status of each switch, the matching network works as a band-switchable matching network. Based on a detailed analysis of the influence of non-ideal switches in the matching network, we conceived a new design perspective for the reconfigurable matching network that achieves low loss. A 900/1900-MHz dual-band, 1 W class PA is newly designed following the new design perspective, and fabricated with microelectro mechanical system (MEMS) SPST switches. Owing to the new design and sufficient characteristics of the MEMS switches, the dual-band PA achieves over 60% of the maximum power-added efficiency with an output power for each band exceeding 30 dBm. These results are comparable to the estimated results for a single-band PA. This shows that the proposed scheme provides a band-switchable highly efficient PA that has superior performance compared to the conventional multi-band PA that has a complex structure.

This paper presents a novel frequency-controlled beam steering scheme for a phased-array antenna system (PAS). The proposed scheme employs phase-controlled carrier signals to form the PAS beam. Two local oscillators (LOs) and delay lines are used to generate the carrier signals. The carrier of one LO is divided into branches, and then the divided carriers passing through the corresponding delay lines have the desired phase relationship, which depends on the oscillation frequency of the LO. To confirm the feasibility of the scheme, four-branch PAS transmitters are configured and tested in a 10-GHz frequency band. The results verify that the formed beam is successfully steered in a wide range, i.e., the 3-dB beamwidth of approximately 100 degrees, using LO frequency control.