This paper presents a novel design scheme for a band-switchable multi-band power amplifier (BS-MPA). A key point of the design scheme is configuring multi-section reconfigurable matching networks (MR-MNs) optimally in terms of low loss matching in multiple frequency bands from 0.7 to 2.5 GHz. The MR-MN consists of several matching sections, each of which has a matching block connected to a transmission line via a switch. Power dissipation at an actual on-state switch results in the insertion loss of the MR-MN and depends on how the impedance is transformed by the MR-MN. The proposed design scheme appropriately transforms the impedance of a high power transistor to configure a low loss MR-MN. Numerical analyses show quantitative improvement in the loss using the proposed scheme. A 9-band 3-stage BS-MPA is newly designed following the proposed scheme and fabricated on a multi-layer low temperature co-fired ceramic substrate for compactness. The BS-MPA achieves a gain of over 30 dB, an output power of greater than 33 dBm and a power added efficiency of over 40% at the supply voltage of 4 V in each operating band.

The purpose of this paper is to investigate the possible impact of cellular phones' signals on implantable cardiac pacemakers in elevators. This is achieved by carrying out precise numerical simulations based on the Finite-Difference-Time-Domain method to examine the electromagnetic fields in elevator models. In order to examine the realistic and complicated situations where humans are present in the elevator, we apply the realistic homogeneous human phantom and cellular radios operating in the frequency bands 800 MHz, 1.5 GHz and 2 GHz. These computed results of field strength inside the elevator are compared with a certain reference level determined from the experimentally obtained maximum interference distance of implantable cardiac pacemakers. This enables us to carry out a quantitative evaluation of the EMI risk to pacemakers by cellular radio transmission. The results show that for the case when up to 5 mobile radio users are present in the elevator model used, there is no likelihood of pacemaker malfunction for the frequency bands 800 MHz, 1.5 GHz and 2 GHz.

The objective of this paper is to extend the dosimetric assessment of 35mm Petri dishes exposed in the standing wave of R18 waveguides operated at 1950MHz for a medium-oil two-layer configuration for cells in monolayer and suspension. The culture medium inside the Petri dish is covered by oil that prevents evaporation and seals the cells below in the medium. The exposure of the cells was analyzed for one suspension-medium configuration, two different suspension-multilayer configurations, and one monolayer-multilayer configuration. The numerical dosimetry is verified by dosimetric temperature measurements. The non-uniformity of the specific absorption rate (SAR) distribution is 30% for monolayer, and 59-75% for suspension configurations. The latter should be taken into account when biological experiment is performed.

A multi-terminal serial optical link(MSOL) achieves very simple and cost effective radio cell configurations because only one pair of fibers is needed. In addition, low cost Fabry-Perot laser diodes(FP-LDs) can be employed. MSOL has a substantial problem in that the beat noise degrades the C/N in the up-link. To reduce this noise, we propose using an automatic wavelength-offset control(AWOC) circuit. The AWOC circuit offsets the LD wavelength by controlling the laser bias current to minimise the RF band beat noise which is inherent in MSOL systems, and enables high C/N optical-microwave transmission. An experimental MSOL consisting of 5 radio access stations, each equipped with AWOC, is constructed to estimate the noise free dynamic range for 800-MHz 20-carrier signal transmission. The up-link comprises a single mode fiber connecting five 1.3-µm FP-LDs operating at 0.2 mW. The down-link consists of a single mode fiber and one 1.3-µm Distributed Feedback type Laser Diode(DFB-LD) emitting at 4.0 mW. The experimental device achieves over 15 dB noise reduction compared to MSOL without AWOC in the temperature range of 0 to 40. By using the proposed AWOC, MSOL can achive low cost optical fiber RF microcell systems that are easy to install. Additionally, when we install MSOL in the radio base station, the links become more cost effective than coaxial cable links; they offer a wide dynamic range and higher transmission quality.

Finite-difference time-domain (FDTD) analysis is performed to evaluate the distributions of specific absorption rate (SAR) in a human head during use of a handheld portable telephone. A heterogeneous head model has been assumed which is comprised of 273 108 cubic cells 2.5 mm on a side, with the electrical properties of anatomical equivalents. A handset model has been assumed to be a metal box with either a quarter-wavelength monopole or a half-wavelength dipole operating at 900 MHz or 1.5 GHz. The maximum local SARs in the head are evaluated under various exposure conditions. The dependence of the maximum local SARs on the difference in the structures or parameters of the model, i.e. the distance between the antenna and the head, the heterogeneity of the head, the antenna type, the volume of the smoothing region of the local SAR value, skin electrical constants, and the presence or absence of auricles, are examined. It is shown that the heterogeneity of the head barely affect the maximum local SAR when the telephone is located sufficiently close to the head. It is also shown that the electrical constants of skin which has lower conductivity provide the lower maximum local SAR in the head while the maximum local SAR within the brain is not significantly affected. The auricle which lies in closest proximity to the antenna is shown to have significant effect on the maximum local SAR. It is suggested that the presence of the auricle enhances the maximum local SAR by a factor that is 1.7-2.4 larger than the model without auricles.

The aim of this study is to develop a new whole-body averaged specific absorption rate (SAR) estimation method based on the external-cylindrical field scanning technique. This technique is adopted with the goal of simplifying the dosimetry estimation of human phantoms that have different postures or sizes. An experimental scaled model system is constructed. In order to examine the validity of the proposed method for realistic human models, we discuss the pros and cons of measurements and numerical analyses based on the finite-difference time-domain (FDTD) method. We consider the anatomical European human phantoms and plane-wave in the 2 GHz mobile phone frequency band. The measured whole-body averaged SAR results obtained by the proposed method are compared with the results of the FDTD analyses.

An ultra low-noise and highly selective, experimental 2-GHz band cryogenic receiver front end (CRFE) has been newly developed for cellular base stations. It utilizes a high-Q superconducting filter, a very low noise cryogenic amplifier, and a highly reliable cooler that is very compact. Fundamental design of the CRFE is investigated. First, the equivalent noise temperature of the CRFE and the effect of improving CRFE sensitivity on base station reception are discussed. Next, essential technologies and fundamental characteristics of each component are described. Finally, influence of antenna noise, such as ground noise and man-made noise, is estimated through field tests both in urban and suburban areas.

An experimental SAR (Specific Absorption Rate) estimation system based upon the thermograph method using a thermograph camera and newly developed homogeneous dry-phantom human models are presented. Experiments are conducted using this system and UHF fields to obtain SAR distributions in the human head irradiated by hand-held portable radios. Experiment results show that the estimated peak SAR's due to the radiation waves from radios of 1W transmitting power are lower than 2W/kg and so conform to the recommendations of the radio-frequency radiation safety guidelines. The developed system enables the surface SAR distributions on the phantom model to be precisely estimated; a function not available with the original system. System parameters required for providing precise estimations are discussed first, and then experiments are conducted to estimate SAR's in the human head exposed to a UHF hand-held portable radio's near field. Finally, estimated data are examined from the viewpoint of radio-frequency exposure safety guidelines.

This paper proposes new techniques to simulate a MIMO propagation channel using the ray-tracing method for the purpose of decreasing the computational complexity. These techniques simulate a MIMO propagation channel by substituting the propagation path between a particular combination of transmitter and receiver antennas for all combinations of transmitter and receiver antennas. The estimation accuracy calculated using the proposed techniques is evaluated based on comparison to the results calculated using imaging algorithms. The results show that the proposed techniques simulate a MIMO propagation channel with low computational complexity, and a high level of estimation accuracy is achieved using the proposed Vector-Rotation Approximation technique compared to that for the imaging algorithm.

This paper presents an experimental investigation on the RF characteristics of a 3W-class cryogenically-cooled receiver amplifier employing a gallium-nitride high electron mobility transistor (GaN HEMT) with a blue light for mobile base stations. In general, a cryogenically-cooled receiver amplifier using a GaN HEMT exhibits unstable DC characteristics similar to those found in the current collapse phenomenon because the GaN HEMT loses thermal energy at cryogenic temperatures. The fabricated cryogenically-cooled receiver amplifier achieves stable DC characteristics by injecting blue light into the GaN HEMT instead of thermal energy. Experimental results show that the amplifier achieves fine stable DC characteristics for deviation in the drain-source current from 42% to 5% and RF characteristics for a maximum power added efficiency from 58% to 68% without and with the blue light at 60,K. The fabricated amplifier is effective in reducing the power consumption at cryogenic temperatures. To the best of our knowledge, this paper is the first report regarding RF characteristics of a cryogenically-cooled receiver amplifier using a blue light for mobile base stations.

This paper describes a numerical assessment methodology of pacemaker EMI triggered by HF-band wireless power transfer system. By using three dimensional full-wave numerical simulation based on finite element method, interference voltage induced at the connector of the pacemaker inside the phantom that is used for in-vitro EMI assessment is obtained. Simulated example includes different exposure scenarios in order to estimate the maximum interference voltage.

The purpose of this study is to establish a whole-body averaged specific absorption rate (WB-SAR) estimation method using the power absorbed by humans; a cylindrical-external field scanning technique is used to measure the radiated RF (radio-frequency) power. This technique is adopted with the goal of simplifying the estimation of the exposure dosimetry of humans who have different postures and/or sizes. In this paper, to validate the proposed measurement method, we subject numerical human phantom models and cylindrical scanning conditions to FDTD analysis. We design a radiation system that uses a dielectric lens to achieve plane-wave irradiation of tested human phantoms in order to develop an experimental WB-SAR measurement system for UHF far-field exposure condition. In addition, we use a constructed SAR measurement system to confirm absorbed power estimations of simple geometrical phantoms and so estimate measurement error of the measurement system. Finally, we discuss the measurement results of WB-SARs for male adult and child human phantom models.

This paper proposes the test phantom for the cochlear implant to estimate electromagnetic interference (EMI) from a cellular phone. This test phantom is constructed from a square tank filled with saline solution. The use of a flat phantom provides a level of consistency in duplicating the exposure conditions in the EMI tests. The measurement and calculation results show that there is no difference in the E-field strength near the surface of the phantom when comparing flat and head-shaped phantoms and that the flat phantom is sufficiently thick to disregard the influence of reflective waves near the surface of the phantom. The calculation results also indicate the appropriateness of using physiological saline (0.18 g/l) up to 3 GHz when comparing the E-field strength inside a phantom comprising physiological saline and in a 2/3 muscle model. The results of actual EMI testing of a cochlear implant show that there is no difference in the maximum interference distance when using either the flat or head-shaped phantom. Based on these results, this paper presents the validity of using the flat phantom in EMI tests from cellular phone for the cochlear implant.

High efficiency amplifier construction techniques are investigated focusing on UHF band transmitting power amplifiers intended for cellular portable telephones and the state of the art amplifiers are presented. First, it is shown that high efficiency amplifiers are indispensable to attain pocket sized portable units through a theoretical analysis using a simple model. When about 1 W of transmitting power is required, it is desirable for the amplifier to operate with an efficiency of over 40%. Secondly, the switching mode scheme is described as the most effective technical means to achieve high amplifier efficiency. State of the art switching mode amplifiers, the Harmonic Reaction Amplifier (HRA) and the Linearized Saturation Amplifier with Bidirectional Control (LSA-BC), are presented as examples of nonlinear and linear amplifiers respectively. Basic operation mechanisms are shown. Experimental HRA and LSA-BC are constructed to determine their practically attainable efficiencies. Power-added efficiencies of 75% and 40% are recorded from a 1.7 GHz band 3 W HRA for CW and a 1.5 GHz band 1 W LSA-BC for π/4 QPSK respectively. These values indicate that these types of amplifier can be applied to pocket sized portable radio units.

The electromagnetic field (EMF) distributions created inside a train carriage by the cellular radios of the passengers are analyzed and the impact their electromagnetic interference (EMI) on the implantable cardiac pacemakers is evaluated based upon the analysis results. Both computer simulations and experiments using 800 MHz and 2 GHz transmitters in an actual train carriage confirm that excessively high EMF, high enough to affect the normal functions of the pacemaker, does not occur inside the carriage provided the safe distance of 22 cm specified for pacemaker users is kept. A simplified histogram estimation method for electric field strength is newly developed to deal with the complicated EMF distributions. It allows the EMI risk to pacemakers by cellular radio transmission to be quantitatively evaluated. Methodologies are described first. Typical results of FDTD analysis and actual measurement data are then shown. Finally, considerations and conclusions are made.

The Finite-Difference Time-Domain (FDTD) technique is presented in this paper as an estimation method for radio propagation prediction in large and complex wireless local area network (WLAN) environments. Its validity is shown by comparing measurements and Ray-trace method with FDTD data. The 2 GHz (802.11b/g) and 5 GHz (802.11a) frequency bands are used in both the calculations and experiments. The electric field (E-field) strength distribution has been illustrated in the form of histograms and cumulative ratio graphs. By using the FDTD method to vary the number of human bodies in the environment, the effects on E-field distribution due to human body absorption are also observed for 5 GHz WLAN design.

Recent cellular systems have excellent performances, such as high quality, compactness, low power consumption and low cost, owing not only to digital technologies but also to various RF device technologies, especially amplifier technologies. This paper describes base station RF technologies that contributed for the improvement of base station equipment. Future mobile system will provide much higher bitrate services in the higher frequency band. Requirements and new technologies that are expected for RF equipment of the future base stations are also discussed.

A new structure of a low-loss high temperature superconducting (HTS) filter is proposed by using quarter-wavelength coplanar waveguide (CPW) resonators. A 4-pole Chebyshev band-pass filter with the center frequency 5.0 GHz and the 0.01 dB-ripple fractional bandwidth 3.2% is designed based on the theory of direct-coupled resonator filters using K- and J-inverters. This filter is fabricated by using a high-Tc superconductive YBCO film deposited on a MgO dielectric substrate. The frequency response of the filter measured at 60 K agrees very well with the theoretical one. The insertion loss is 0.22 dB. The insertion loss of this filter is the lowest in HTS-CPW filters presented so far.