Miniaturized millimeter-wave HMIC amplifiers have been developed by using capacitively-coupled matching circuits (CCMC) and FETs with resistive source-stubs. CCMC includes FET's parasitic reactances, and is able to reduce the size of a matching circuit in a HMIC amplifier to about 1/3 of a conventional matching circuit using an open-circuited stub for matching and a quarter-wavelength coupled-line for d. c. blocking. The resistive source-stubs, which consist of two open-circuited stubs and a resistor, can improve the gain and stability of FETs at millimeter-wave frequencies. In this paper, design procedures of CCMC and the resistive source-stubs are described, and their usefulness has been confirmed experimentally through measurements of prototype V-band high-power HMIC amplifiers.

A novel compact T/R (Transmit/Receive) switching circuit for wideband T/R modules has been proposed. It employs quadrature couplers and gate-and-drain-driven HPAs to remove circulators or T/R switches from a conventional T/R module, and T/R switching is made with controlling biasing conditions of the FETs in HPAs. Furthermore, an optimum biasing condition and design of output matching circuit of the HPA have been studied to reduce loss in RX-mode, and the validity of the method has been confirmed by measurements.

A novel design method for wideband low-noise multi-stage amplifiers is presented. It utilizes a RL-SFC (esistive oaded eries eedback ircuit) comprised of a series feedback circuit with additional lossy match stubs to achieve low noise figure, low VSWRs, flat gain, and high stability simultaneously. In addition, each stage amplifier employs a different approach for designing the RL-SFC to achieve the best compromise between noise figure, VSWR, gain, and stability as a multi-stage amplifier. With the use of this novel design method, the 3-stage amplifier has demonstrated the state-of-the-art wideband low-noise performance of 2.3 dB over 6 to 18 GHz.

A matched load for post-wall waveguide (SIW; Substrate Integrated Waveguide) is presented. It consists of an electrically-shorted post-wall waveguide and a rectangular thin-film resistor sheet on the surface of the waveguide, resulting in a quite compact structure without three-dimensional bulky absorber as in conventional waveguide matched loads. A fabricated X-band matched load has achieved less than -20 dB reflection in more than 20% relative bandwidth.

A new elliptic-function bandpass filter (BPF) is proposed, which utilizes an inter-digital coupled line (IDCPL) as a left-handed transmission line. The IDCPL is employed in order to realize a negative coupling between non-adjacent resonators in a wideband BPF. As the authors' knowledge, the left-handed operations of the IDCPL has rarely utilized before, although the IDCPL itself has been widely used in many microwave circuits without being paid attention to the left-handed operations. Measured characteristics of two BPFs are presented in this paper, one is targeted for 3-4 GHz WiMAX systems, and the other is for 3-5 GHz ultra wideband communication systems (UWB).