An all-digital time-domain ADC, abbreviated as TAD, is presented in this paper. All-digital structure is intrinsically compatible with the scaling of CMOS technology, and can satisfy the great demand of miniaturized and low-voltage sensor interface. The proposed TAD uses an inverter-based Ring-Delay-Line (RDL) to transform the input signal from voltage domain to time domain. The voltage-modulated time information is then digitized by a composite architecture namely “4-Clock-Edge-Shift Construction” (4CKES). TAD features superior voltage sensitivity and 1st-order noise shaping, which can significantly simplify the power-hungry pre-conditioning circuits. Reconfigurable resolution can be easily achieved by applying different sampling rates. A TAD prototype is fabricated in 65nm CMOS, and consumes a small area of 0.016mm2. It achieves a voltage resolution of 82.7µV/LSB at 10MS/s and 1.96µV/LSB at 200kS/s in a narrow input range of 0.1Vpp, merely under 0.6V supply. The highest SNR of TAD prototype is 61.36dB in 20kHz bandwidth at 10MS/s. This paper also analyzes the nonideal effects of TAD and discusses the potential solutions. As the principal drawback, nonlinearity of TAD can be compensated by the differential-setup and digital calibration.

The development of highly accurate and durable control system is becoming a must for todays high performance automobiles. For example, it is necessary to up-grade todays materials and methods creating more sensitive sensors, higher speed processors and more accurate actuators, while also being more durable. Thus, the development of a CMOS time-to-digital converter LSI with half-nanosecond resolution, which controls only pulse signals was achieved by employing 1.5 µm CMOS technology. The new signal detecting circuit, 1.1 mm2 in size, converts time to numerical values over a wide measurement range (13 bits). The compact digital circuit employs a newly developed "ring gate delay system". Within the LSI the fully digital circuit is highly durable. This allows it to be utilized even under severe conditions (for example an operating ambient temperature of 130). In order to measure time accurately, a method of correcting the variation of measurement time data employing a real-time conversion fully digital circuit is described. This method allows for fully automatic correction with a microcomputer, so no manual adjustment is required. In addition to sensor circuit applications, the LSI has great potential for Application Specific Integrated Circuit, (ASIC) such as a function cell with is a completely new method of measuring time.