A new shared multibuffer architecture for high-speed ATM (Asynchronous Transfer Mode) switch LSIs is described. Multiple buffer memories are located between two crosspoint switches. By controlling the input-side crosspoint switch so as to equalize the utilization rate of each buffer memory, these multiple buffer memories can be recognized as a single large shared buffer memory. High utilization efficiency of buffer memory can thus be achieved, and the cell loss ratio is minimized. By accessing the buffer memories in parallel via crosspoint switches, the time required to access the buffer memories is greatly reduced. This feature enables high-speed operation of the switch. The shared multibuffer architecture was implemented in a switch LSI using 0.8-µm BiCMOS process technology. Experimental results revealed that this chip can operate at more than 125 MHz. Bit-sliced eight switch LSIs operating at 78 MHz construct a 622-Mb/s 88 ATM switching system with a buffer size of 1,024 ATM cells. Power consumption of the switch LSI was 3 W.

A new ATM switch architecture, named shared multibuffering, features great advantages on memory access speed for a large switch, and overall size of buffer memories to achieve excellent cell-loss performance. We have developed a 622-Mb/s 88 shared multibuffer ATM switch with multicast functions and hierarchical queueing functions to accommodate 156-Mb/s, 622-Mb/s and 2.4-Gb/s interfaces. Implementation of the shared multibuffer ATM switch is described with respect to the four sorts of 0.8-µm BiCMOS LSIs and ATM switch boards. The switch board/type-1, with C1-LSI, allows to accommodate effectively 156-Mb/s and 622-Mb/s interfaces, which is suitable for an ATM access system. The switch board/type-2, with C2-LSI, can provide multicast functions and accommodate a 2.4-Gb/s interface. By using four switch boards, it is possible to apply them to a 2.4-Gb/s ATM loop system.