Efficient multiplexing of ultra-reliable and low-latency communications (URLLC) and enhanced mobile broadband (eMBB) traffic, as well as ensuring the various reliability requirements of these traffic types in 5G wireless communications, is becoming increasingly important, particularly for vertical services. Interference management techniques, such as coordinated inter-cell scheduling, can enhance reliability in dense cell deployments. However, tight inter-cell coordination necessitates frequent information exchange between cells, which limits implementation. This paper introduces a novel RAN slicing framework based on centralized frequency-domain interference control per slice and link adaptation optimized for URLLC. The proposed framework does not require tight inter-cell coordination but can fulfill the requirements of both the decoding error probability and the delay violation probability of each packet flow. These controls are based on a power-law estimation of the lower tail distribution of a measured data set with a smaller number of discrete samples. As design guidelines, we derived a theoretical minimum radio resource size of a slice to guarantee the delay violation probability requirement. Simulation results demonstrate that the proposed RAN slicing framework can achieve the reliability targets of the URLLC slice while improving the spectrum efficiency of the eMBB slice in a well-balanced manner compared to other evaluated benchmarks.

Low-latency and highly reliable communication on wireless LAN (WLAN) is difficult due to interference from the surroundings. To overcome this problem, we have developed a scheme called Clear to Send-to-Station (CTS-STA) frame transmission control that enables stable latency communication in environments with strong interference from surrounding WLAN systems. This scheme uses the basic functions of WLAN standards and is effective for both the latest and legacy standard devices. It operates when latency-strict transmission is required for an STA and there is interference from surrounding WLAN devices while minimizing the control signal overhead. Experimental evaluations with prototype systems demonstrate the effectiveness of the proposed scheme.

Communication systems operating in the millimeter-wave (mmWave) band have the potential to realize ultra-high throughput and ultra-low latency vehicle-to-vehicle (V2V) communications in 5G and beyond wireless networks. Moreover, because of the weak penetration nature of mmWave, one mmWave channel can be reused in all V2V links, which improves the spectrum efficiency. Although the outstanding performance of the mmWave above has been widely acknowledged, there are still some shortcomings. One of the unavoidable defects is multipath interference. Even though the direct interference link cannot penetrate vehicle bodies, other interference degrades the throughput of the mmWave V2V communication. In this paper, we focus on the multipath interference caused by signal reflections from roads and surroundings, where the interference strength varies in road scenarios. Firstly, we analyze the multipath channel models of mmWave V2V with relay in three typical road scenarios (single straight roads, horizontal curves, and slopes). Their interference differences are clarified. Based on the analysis, a novel method of ZigZag antenna configuration is proposed to guarantee the required data rate. Secondly, the performance of the proposed method is evaluated by simulation. It proves that the ZigZag antenna configuration with an optimal antenna height can significantly suppress the destructive interference, and ensure a throughput over 1Gbps comparing to the conventional antenna configuration at 60GHz band. Furthermore, the effectiveness of ZigZag antenna configuration is demonstrated on a single straight road by outdoor experiments.

Controlling interference from the secondary system (SS) to the receiver of the primary system (PS) is an important issue when the SS uses the same frequency band as the television broadcast system. The reason includes that the SS is unaware of the interference imposed on the primary receiver (PS-Rx), which does not have a transmitter. In this paper, we propose an interference control method between PS-Rx and SS, where a load modulation scheme is introduced to the PS-Rx. In this method, the signal from the PS transmitting station is scattered by switching its load impedance. The SS observes the scattered channel and calculates the interference suppression weights for transmitting, and controls interference by transmit beamforming. A simulation shows that the Signal-to-Interference Ratio (SIR) with interference control is improved by up to 41.5dB compared to that without interference control at short distances; the results confirm that the proposed method is effective in controlling interference between PS-Rx and SS. Furthermore, we evaluate the Signal-to-Noise Ratio (SNR) and channel capacity at SS.

In heterogeneous cellular networks (HCN), which consists of macrocells and numerous femtocells, efficient interference management schemes between macrocells and femtocells are so crucial to the overall system performance. To mitigate intercell interference in HCN, we propose a new rate-split transmission scheme which has the following characteristics. First, it supports user quality of service (QoS) with the least intercell interference. Second, it is a low complexity and distributed scheme using only Interference to Signal and Noise Ratio (ISNR). An evaluation confirms that the proposed scheme offers better performance than legacy schemes which are not considering user QoS.

In heterogeneous cellular networks (HCN), which consists of macrocells and picocells, efficient interference management schemes between macrocells and picocells are crucial to the overall system performance. We propose a dynamic cooperative silencing (DCS) scheme for intercell interference control (ICIC). It is a low-complexity, low-feedback and distributed algorithm using only strongly interfered neighboring user information. A system simulation shows that the system performance and in particular the cell-edge throughput is significantly increased with the proposed silencing scheme.