In this paper, a multistage parallel interference canceller (MPIC) with multiple-beam reception for a DS-CDMA system is proposed to suppress multiple access interference (MAI) effectively. Its aim is to reduce the computational complexity of the conventional MPIC cascaded with an adaptive array antenna. It employs multiple fixed beams based on phased array and selects suitable beams to demodulate the transmitted signal of each user. Then it suppresses residual interference signals by the MPIC cascaded with multiple-beam receiver. Its bit error rate (BER) performance is evaluated by computer simulations assuming an uplink single-chip-rate multiple-spreading-factor DS-CDMA system over both exponentially decaying 5-path and equal average power 2-path Rayleigh distributed channels. When there are 16 users in an 120-sectored single cell, the proposed receiver with 6-element array antenna and 2-stage MPIC shows better or comparable BER performance compared with that of the conventional receiver. Moreover, the proposed receiver with 8 beams can reduce the number of complex multiplications to about 40% of that of the complexity-reduced conventional receiver over 5-path channels.

A compact open-loop resonator bandpass filter is presented to suppress the spurious passband using compensated compact microstrip resonant cell (C-CMRC) feeding structure. Based on the inherently compact and stopband characteristics of the C-CMRC feeding, the proposed filters shows a better spurious rejection performance than the only open-loop resonator filter. The suppression is -57.4 dB, -49.5 dB, and -43.9 dB at the 2nd, 3rd and 4th harmonic signal separately. All the performance of proposed filters have been verified by the measured results.

We proposed a method for suppressing arc ignition in mechanical contact devices using a transient current switch and a capacitor. We applied the method to conventional reed switches. For the electric circuit analysis, we clarified the momentary voltage-current characteristics at breaking operation of reed switches by FEM analysis. We could also estimate the capacitance of the contact electrodes at the metal bridge rupture by FEM analysis, and would derive the non-arcing condition using SPICE simulation. The suitable capacitor value in the transient current circuit for arc ignition suppression would be depend on the load impedance, the power supply, the time depending contact resistance R(t)s, the contact capacitance, and the minimum arc voltage and current.

This investigation proposes a modified equivalent circuit of single complementary split-ring resonator (CSRR) in planar transmission media and a dual-mode ring bandpass filter (BPF) that uses periodic CSRRs to suppress the spurious response. The proposed modified equivalent circuit consists of lumped elements that can be easily extracted from the measured S parameters. The proposed dual-mode ring BPF has exhibits a wide stopband characteristic owing to the bandgap resonant characteristic of CSRRs in the harmonic frequency of the dual-mode ring BPF. Good agreement with EM simulation and measurement is demonstrated.

This paper proposes a novel pre-FFT type OFDM adaptive array antenna called "Eigenvector Combining." The eigenvector combining array antenna is a realization of a post-FFT type OFDM adaptive array antenna through a pre-FFT signal processing, so it can achieve excellent performance with less computational complexity and shorter training symbols. Numerical results demonstrate that the proposed eigenvector combining array antenna shows excellent bit error rate performance close to the lower bound just with 2 OFDM symbol-long training symbols.

This paper proposes a parallel coupled microstrip bandpass filter (BPF) with ring Electromagnetic Bandgap (EBG) cells on the middle layer for spurious suppression. The ring EBG cells of the middle layer add a good stopband-rejection mode to the second harmonics of the parallel coupled microstrip BPF with suppression of over -50 dB, without affecting the center frequency and insertion loss of the original designed BPF. The design of ring EBG cells is presented and verified by the experimented results.

A novel class of microstrip bandpass filter is configured using the impedance transformers and an improved stepped impedance resonator (SIR). This SIR is composed of a central narrow strip section with an aperture on ground and two wide strip sections at the two sides. This low-high-low SIR resonator has a promising capability in achieving an extremely large ratio of first two resonant frequencies for design of a bandpass filter with ultra-broad stopband. The two quarter-wavelength transformers with low and high impedances, referred as to impedance- and admittance-inverters, are modeled and utilized as alternative types of inductive and capacitive coupling elements with highly tightened degrees for wideband filter design. After extensive investigation is made on the two transformers and the proposed SIR, the two novel bandpass filters are constructed, designed and implemented. Two sets of predicted and measured frequency responses over a wide frequency range both quantitatively exhibit their several attractive features, such as ultra-broad stopband with deep rejection and broadened dominant passband with low insertion loss.

For emission from a printed circuit board (PCB) by the common-mode current, the suppression method based on the image theory by placing a conducting plate under the PCB is presented. In order to evaluate the suppression effect by this method the radiation power from the PCB is calculated by using FDTD method. The numerical results show that placing the conducting plate suppresses the emission by the common-mode current. Especially, using the conducting plate bent the sides, it is possible to suppress the emission by the small conducting plate. Further, the experimental results of a radiation power and a maximum electric field intensity show the validity of the numerical results.

This paper presents designs and performances of 76 GHz band alternating-phase fed single-layer slotted waveguide arrays. Two kinds of design, that is, uniform aperture illumination for maximum gain and Taylor distribution for sidelobe suppression of -25 dB, are conducted. High gain and high efficiency performance of 34.8 dBi with 57% is achieved for the former, while satisfactory sidelobe suppression of -20 dB in the H-plane and -23 dB in the E-plane with high efficiency is confirmed for the latter. The simple structure dispensing with electrical contact between the slotted plate and the groove feed structure is the key advantage of alternating-phase fed arrays and the slotted plate is just tacked on the feed structure with screws at the periphery. High gain and high efficiency performances predicted theoretically as well as design flexibility of the alternating-phase fed array are demonstrated in the millimeter wave frequency.

The issue of importance of multiuser detection for CDMA-based mobile ad hoc networks is addressed in this paper. For conventional scheme, each terminal in the network uses matched filter to receive packets, so the performance (e.g., throughput) of the network suffers from multi-access interference (MAI). Different from above scheme, in this paper, each terminal of the ad hoc network is equipped with an adaptive blind linear multiuser detector, so the ability of MAI-resistance is gained. Employing slotted-ALOHA protocol in MAC layer and using fully-connected network model, the throughput of ad hoc network is studied. Theoretic analysis and simulation results show that multiuser detection can remarkably improve throughput performance of ad hoc networks.

A side-coupled microstrip open-loop resonator is presented for design of harmonic-suppressed bandpass filters with compact size. In geometry, the open-ended microstrip feed line is put in close proximity to the loop resonator at the opposite side of an opened-gap. In design, its length is properly lengthened to establish the orthogonal even- and odd-symmetrical current distributions along the two coupled strip conductors. It thus results in cancellation the 1st parasitic resonance. The two-stage open-loop filter is first constructed and its performance is studied under varied feed line lengths. Furthermore, a four-stage filter block is optimally designed at 2.52 GHz and its circuit sample is fabricated with the overall length less than 60% of one guided wavelength. The measured insertion loss at the 1st harmonic is higher than 30 dB, the stopband covers the range from 2.8 GHz to 7.0 GHz, and the dominant pass bandwidth is about 9.0%.

We propose a new electric contact device for arc discharge suppression. The functions of conventional electric contacts are categorized into energizing switch contacts and transient current switch contacts. A capacitor is connected in series to a transient current switch. Suppression of power consumption and arc discharge at breaking contacts are proposed, experimentally measured, and theoretically analyzed. The transient V-I characteristics at breaking contacts are controlled by the transient current switch and the capacitor. The transient responses at contacts were numerically derived by SPICE, and the energizing switch contacts voltage could be controlled to less than the minimum arc voltage. Using 2 conventional relays, no arc ignition at breaking contacts was confirmed for 50 V/25 A.

This paper presents two novel blind set-theoretic adaptive filtering algorithms for suppressing "Multiple Access Interference (MAI)," which is one of the central burdens in DS/CDMA systems. We naturally formulate the problem of MAI suppression as an asymptotic minimization of a sequence of cost functions under some linear constraint defined by the desired user's signature. The proposed algorithms embed the constraint into the direction of update, and thus the adaptive filter moves toward the optimal filter without stepping away from the constraint set. In addition, using parallel processors, the proposed algorithms attain excellent performance with linear computational complexity. Geometric interpretation clarifies an advantage of the proposed methods over existing methods. Simulation results demonstrate that the proposed algorithms achieve (i) much higher speed of convergence with rather better bit error rate performance than other blind methods and (ii) much higher speed of convergence than the non-blind NLMS algorithm (indeed, the speed of convergence of the proposed algorithms is comparable to the non-blind RLS algorithm).

We proposed a new electric contact device that suppresses the arc phenomena. The functions of electric contacts are divided into energizing and switching for arc suppression. Switching contacts consist of multielectrodes and each electrode current is suppressed by the series resistance. For realization of multicontacting, cantilever beam array electrodes were formed on a silicon substrate using micro-electromechanical systems (MEMS) technology. The finite element method was used to optimize the structure. The fabrication process of the cantilever was examined. Au-Au contact current of 0.97 A was broken without arc ignition.

In a CDMA non-linear interference canceller, a generated replica of an interference signal is multiplied by a positive number smaller than unity, which is called cancellation moderating factor (CMF), to prevent interference enhancement due to inaccurate replica subtraction. In this paper, two CMF controlling schemes applicable to a multistage parallel interference canceller with multi-antenna (spatial diversity) reception are proposed. They control CMF by using the mean square error of the complex channel gain or by using the ratio of the estimated power of each interference signal to remaining interference signals' power, in order to mitigate the replica subtraction error due to inaccurate channel estimation. The performance of the proposed schemes are evaluated by computer simulations assuming an asynchronous uplink single chip-rate variable spreading factor DS-CDMA system. The simulation results show that the proposed schemes with higher order diversity reception improve the bit error rate (BER) performance compared with a conventional scheme considering the tentative decision error or fixed CMF settings. Their performance improvement is by 0.1-0.9 dB in terms of the required Eb/N0 at an average BER of 10-5 over exponentially decaying 5-path Rayleigh distributed channels when the number of receiving antennas is 6.

A robust microphone array for speech enhancement and noise suppression is studied in this paper. To overcome target signal cancellation problem of conventional beamformer caused by array imperfections or reverberation effects of acoustic enclosure, the proposed microphone array adopts an arbitrary model of channel transfer function (TF) relating microphone and speech source. Since the estimation of channel TF itself is often intractable, herein, transfer function ratio (TFR) is estimated instead and used to form a suboptimal beamformer. A robust TFR estimation method is proposed based on signal subspace analysis technique against stationary or slowly varying noise. Experiments using simulated signal and actual signal recorded in a real room illustrate that the proposed method has high performance in adverse environment.

A new Row-by-Row Dynamic Source-Line Voltage Control (RRDSV) scheme is proposed to suppress leakage current by two orders of magnitude in the SRAM's for sub-70 nm process technology with sub-1-V VDD. This two-order leakage reduction is caused from the cooperation of reverse body-to-source biasing and Drain Induced Barrier Lowering (DIBL) effects. In addition, metal shields are proposed to be inserted between the cell nodes and the bit lines not to allow the cell nodes to be flipped by the external bit-line coupling noise in this paper. A test chip has been fabricated to verify the effectiveness of the RRDSV scheme with the metal shields by using 0.18-µm CMOS process. The retention voltages of SRAM's with the metal shields are measured to be improved by as much as 40-60 mV without losing the stored data compared to the SRAM's without the shields.

In this letter, a novel design of a branch-line coupler with considerable reduction in its size and suppressed harmonic passband is proposed. By embedding a defected ground structure (DGS) unit cell under a microstrip line, compact branch-line couplers are easily achieved. The electrical length is scaled appropriately according to the slow-wave effect. In this case, the experimental coupling (S21 or S31) is comparable to that of conventional branch-line couplers. Also, experimental results indicate that DGS section is quite effective for the suppression of higher order harmonics.

This paper presents a multiple constrained subspace based multiuser detector for synchronous long-code downlink multirate DS-CDMA systems. The novel receiver adapts its fractionally-spaced equaliser tap-weights based upon two modes, namely training and decision-directed modes. Switching between two modes is achieved by changing the code constraint in the associated subspace algorithm. Moreover, detection of the desired user requires the knowledge of the desired user's spreading code only. Simulation results show that the proposed receiver is capable of multiple access interference (MAI) suppression and multipath mitigation. Besides, the results reveal the improvement in terms of convergence speed and mean square error (MSE) of the proposed receiver over the existing receiver in both static and dynamic environments.

We have proposed and experimentally demonstrated a novel WDM-PON downstream optical link. It is composed of a wavelength-locked FP-LD with a spectrally-sliced FP-LD as an external-injection optical source and operated as directly-modulating in a downstream-traffic transmitter. The downstream transmissions at 622 Mbps and 2.5 Gbps were performed for four channels over 25 km. The proposed WDM-PON downstream transmitter can be expanded up to eight channels by controlling an external-injection optical source of a spectrally-sliced FP-LD. Also, the transmitter has facility of multi-channel selection by controlling temperature. We verified the potential of the transmitter in WDM-PON optical link.