We experimentally studied the polarization mode dispersion (PMD) tolerance of an feed-forward equalizer (FFE) electronic dispersion compensation (EDC) IC in the absence of adaptive control, in 43-Gbit/s RZ-DQPSK transmission. Using a 3-tap FFE IC composed of InP HBTs, differential group delay (DGD) tolerance at a 2-dB Q penalty is shown to be extended from 25 ps to up to 29 ps. When a polarization scrambler is used, the tolerance is further extended to 31 ps. This value is close to the tolerance obtained with adaptive control, without a polarization scrambler.

Multipath routing and the ability to simultaneously use multiple network paths has long been proposed as a means for meeting the reliability and performance improvement goals of a next generation Internet. However, its use causes out-of-order packet delivery, which is well known to hinder TCP performance. While next-generation transport protocols will no doubt better cope with this phenomenon, a complete switch to these new protocols cannot be made on all devices "overnight"; the reality is that we will be forced to continue using TCP on such multipath networks well after deployment of a future Internet is complete. In this paper, we investigate the use of best-effort packet reordering -- an optional network layer service for improving the performance of any TCP session in the presence of out-of-order packet delivery. Such a service holds the promise of allowing unmodified TCP to take advantage of the reliability and performance gains offered by a future multipath-enabled Internet without suffering the adverse performance effects commonly associated with out-of-order packet delivery. Our experiments test the performance of two common TCP variants under packet dispersion with differing numbers of paths and amounts of inter-path latency variance. They were conducted using multipath network and packet reorderer implementations implemented within the Emulab testbed. Our results demonstrate that a simple best-effort reordering service can insulate TCP from the type of reordering that might be expected from use of packet dispersion over disjoint paths in a wide-area network, and is capable of providing significant performance benefits with few ill side-effects.

The scalability of three-stage Clos-network packet switches makes them an attractive approach in implementing large-size packet switches. However, the configuration time of Clos-network switches depends on both the buffering strategy used and the adopted configuration process. To reduce configuration time, this paper focuses on the so-called Memory-Space-Memory (MSM) Clos-network packet switch, where the switch modules in the first and third stages use memory to support resolution of output port contention. The configuration of these switches is then based on a process to dispatch cells from the first-stage modules to the third-stage modules. Therefore, the throughput of an MSM Clos-network switch depends on the dispatching scheme used. This paper introduces a cell dispatching scheme, called maximum weight matching dispatching (MWMD) scheme, for MSM Clos-network switches and a request queue structure in the first-stage modules. The MWMD scheme performs maximum weight matching, similar to that used for input-queued single-stage packet switches, that in combination with the request queues can achieve 100% throughput under independent and identical admissible traffic. This high throughput can be achieved without allocating buffers in the second stage and without expanding the second stage of this three-stage packet switch. A low-complexity dispatching scheme, the maximal oldest-cell-first matching dispatching (MOMD) scheme, is also introduced as an alternative to MWMD. The performance evaluation in this paper shows that MOMD achieves high throughput under unbalanced traffic through the execution of a finite number of iterations.

Unlike the conventional plasma-TVs using the driving circuit with two polarities during the reset and address periods, the cost-effective driving circuit using only the positive voltage level during the reset and address periods is proposed and implemented in the 42-in. plasma-TV.

There is a trend towards flexible radios which are able to cope with a range of wireless communication standards. For the integrated processing of widely different signals -- including single-carrier, multi-carrier, and spread-spectrum signals -- monolithic baseband receivers need universal formats for the signal representation and channel description. We consider a reconfigurable receiver architecture building on concepts from time-frequency (TF) signal analysis. The core elements are TF signal representations in form of a Gabor expansion along with a compatible parameterization of time-variant channels. While applicable to arbitrary signal types, the TF channel parameterization offers similar advantages as the frequency domain channel description employed by orthogonal frequency-division multiplexing receivers. The freedom in the choice of the underlying analysis window function and the scalability in time and frequency facilitate the handling of diverse signal types as well as the adaptation to radio channels with different delay and Doppler spreads. Optimized window shapes limit the inherent model error, as demonstrated using the example of direct-sequence spread-spectrum signaling.

This paper presents an intuitive interaction technique for data exchange between multiple co-located devices. In the proposed system, CrossOverlayDesktop, desktop graphics of the devices are graphically overlaid with each other (i.e., alpha-blended). Users can exchange file data by the usual drag-and-drop manipulation through an overlaid area. The overlaid area is determined by the physical six degrees of freedom (6-DOF) correlation of the devices and thus changes according to users' direct movements of the devices. Because familiar operations such as drag-and-drop can be applied to file exchange between multiple devices, seamless, consistent, and thus intuitive multi-user collaboration is realized. Furthermore, dynamic overlay of desktop graphics allows users to intuitively establish communication, identify connected devices, and perform access control. For access control of the data, users can protect their own data by simply dragging them out of the overlaid area, because only the overlaid area becomes a public space. Several proof-of-concept experiments and evaluations were conducted. Results show the effectiveness of the proposed interaction technique.

We investigated the relationship between ambient illumination and psychological effect by applying a modified color harmony model. We verified the proposed model by analyzing correlation between psychological value and modified color harmony score. Experimental results showed the possibility to obtain the best color for illumination using this model.

Since multiview video coding (MVC) based on H.264/AVC uses a prediction scheme exploiting inter-view correlation among multiview video, MVC encoder compresses multiple views more efficiently than simulcast H.264/AVC encoder. However, in case that the number of views to be encoded increases in MVC, the total encoding time will be greatly increased. To reduce computational complexity in MVC, a fast mode decision using both Macroblock-based region segmentation information and global disparity vector among views is proposed to reduce the encoding time. The proposed method achieves on the average 1.5 2.9 reduction of the total encoding time with the PSNR (Peak Signal-to-Noise Ratio) degradation of about 0.05 dB.

In this paper, we use frequency-domain equalization (FDE) to create coherent optical single-carrier (CO-SC) transmission systems that are very tolerant of chromatic dispersion (CD) and polarization mode dispersion (PMD). The efficient transmission of a 25-Gb/s NRZ-QPSK signal by using the proposed FDE is demonstrated under severe CD and PMD conditions. We also discuss the principle of FDE and some techniques suitable for implementing CO-SC-FDE. The results show that a CO-SC-FDE system is very tolerant of CD and PMD and can achieve high transmission rates over single mode fiber without optical dispersion compensation.

This paper presents a measurement method for determining effective conductivity of copper-clad dielectric laminate substrates in the millimeter-wave region. The conductivity is indirectly evaluated from measured resonant frequencies and unloaded Q values of a number of Whispering Gallery modes excited in a circular disk sample, which consists of a copper-clad dielectric substrate with a large diameter of 20-30 wavelengths. We can, therefore, obtain easily the frequency dependence of the effective conductivity of the sample under test in a wide range of frequency at once. Almost identical conductivity is predicted for two kinds of WG resonators (the copper-clad type and the sandwich type) with different field distribution; it is self-consistent and provides the important foundation for the method if not for the alternative method at this moment. We measure three kinds of copper foils in 55-65 GHz band, where the conductivity of electrodeposited copper foil is smaller than that of rolled copper foil and shiny-both-sides copper foil. The measured conductivity for the electrodeposited copper foil decreases with an increase in the frequency. The transmission losses measured for microstrip lines which are fabricated from these substrates are accurately predicted with the conductivity evaluated by this method.

A replacement of an expensive MgO protective layer with relatively inexpensive Lanthanum Hexa Boride (LaB6) has already been proposed. Since LaB6 is not transparent, unlike MgO, the LaB6 panel employs a long sustain gap structure. Since the sustain gap is 2.6 times larger than the distance between sustain and address electrodes, different driving methods from those of the conventional PDPs have to be adopted. For the driving technique of the sustain period, an application of delayed auxiliary pulses on A electrode and the overlap sustain pulse drive are proposed. Luminance degradation with higher sustain frequency driving can be compensated by use of a 2step sustain pulse driving. Low reset luminance and low address voltage are achieved with a square-ramp technique for the reset period. TV operation is successfully realized on AC PDP which incorporated the LaB6 cathodes.

This paper analyzes transient behaviors of the polarization-mode-dispersion (PMD) vector for the Foschini and Poole's birefringence vector model. We find an asymptotic solution of the corresponding Fokker-Planck equation representing the solution as a superposition of angular components characterized by the Legendre polynomials. The distribution tail for the PMD vector magnitude evolves slowly to the Maxwellian owing to the residual couplings between adjacent angular components. Of particular interest, the distribution tail for the PMD vector magnitude lies well below the Maxwellian fit during the transient.

We investigate numerically the applicability of photonic crystal fiber (PCF) with a uniform air hole structure as a wide-band transmission medium. We show that accumulated dispersion over the PCF can be reduced effectively by optimizing the index profile of dispersion compensating fiber (DCF). We also show that a bandwidth of more than 300 nm will be available for 40 Gbit/s NRZ transmission by using the PCF as a transmission medium instead of conventional 1.3 µm zero-dispersion single-mode fiber (SMF).

Adaptive polarization mode dispersion (PMD) compensation is required for the speed-up and advancement of the present optical communications. The combination of a tunable PMD compensator and its adaptive control method achieves adaptive PMD compensation. In this paper, we report an effective search control algorithm for the feedback control of the PMD compensator. The algorithm is based on the hill-climbing method. However, the step size changes randomly to prevent the convergence from being trapped at a local maximum or a flat, unlike the conventional hill-climbing method. The randomness depends on the Gaussian probability density functions. We conducted transmission simulations at 160 Gb/s and the results show that the proposed method provides more optimal compensator control than the conventional hill-climbing method.

In this paper, a new local matching algorithm, to estimate dense disparity map in stereo vision, consisting of two stages is presented. At the first stage, the reduction of search space is carried out with a high efficiency, i.e. remarkable decrease in the average number of candidates per pixel, with low computational cost and high assurance of retaining the correct answer. This outcome being due to the effective use of multiple radial windows, intensity information, and some usual and new constraints, in a reasonable manner, retains those candidates which satisfy more constraints and especially being more promising to satisfy the implied assumption in using support windows; i.e., the disparity consistency of the window pixels. Such an output from the first stage, while speeding up the final selection of disparity in the second stage due to search space reduction, is also promising a more accurate result due to having more reliable candidates. In the second stage, the weighted window, although not necessarily being the exclusive choice, is employed and examined. The experimental results on the standard stereo benchmarks for the developed algorithm are presented, confirming that the massive computations to obtain more precise matching costs in weighted window is reduced to about 1/11 and the final disparity map is also improved.

We analyze the carrier dynamics in MOSFETs under low-voltage operation. For this purpose the displacement (charging/discharging) current, induced during switching operations is studied experimentally and theoretically for a 90 nm CMOS technology. It is found that the experimental transient characteristics can only be well reproduced in the circuit simulation of low voltage applications by considering the carrier-transit delay in the compact MOSFET model. Long carrier transit delay under the low voltage switching-on operation results in long duration of the displacement current flow. On the other hand, the switching-off characteristics are independent of the bias condition.

We have proposed a terahertz (THz) emitter utilizing two-dimensional plasmons (2DPs) in a super-grating dual-gate (SGG) high electron mobility transistor (HEMT). The plasmon under each grating gate has a unique feature that its resonant frequency is determined by the plasma-wave velocity over the gate length. Since the drain bias voltage causes a linear potential slope from the source to drain area, the sheet electron densities in periodically distributed 2DP cavities are dispersed. As a result, all the resonant frequencies are dispersed and undesirable spectral broadening occurs. A SGG structure can compensate for the sheet electron density distribution by modulating the grating dimension. The finite difference time domain simulation confirms its spectral narrowing effect. Within a wide detuning range for the gate and drain bias voltages giving a frequency shifting of 0.5 THz from an optimum condition, the SGG structure can preserve the spectral narrowing effect.

In this paper, a novel model of Gaussian pulse propagation in optical fiber is proposed to comprehensively analyze the impact of Group Velocity Dispersion (GVD) on the performance of two-dimensional wavelength hopping/time spreading optical code division multiple access (2-D WH/TS OCDMA) systems. In addition, many noise and interferences, including multiple access interference (MAI), optical beating interference (OBI), and receiver's noise are included in the analysis. Besides, we propose to use the heterodyne detection receiver so that the receiver's sensitivity can be improved. Analytical results show that, under the impact of GVD, the number of supportable users is extremely decreased and the maximum transmission length (i.e. the length at which BER 10-9 can be maintained) is remarkably shortened in the case of normal single mode fiber (ITU-T G.652) is used. The main factor that limits the system performance is time skewing. In addition, we show how the impact of GVD is relieved by dispersion-shifted fiber (ITU-T G.653). For example, a system with 321 Gbit/s users can achieve a maximum transmission length of 111 km when transmitted optical power per bit is -5 dBm.

Interpretations by physicians of capsule endoscopy image sequences captured over periods of 7-8 hours usually require 45 to 120 minutes of extreme concentration. This paper describes a novel method to reduce diagnostic time by automatically controlling the display frame rate. Unlike existing techniques, this method displays original images with no skipping of frames. The sequence can be played at a high frame rate in stable regions to save time. Then, in regions with rough changes, the speed is decreased to more conveniently ascertain suspicious findings. To realize such a system, cue information about the disparity of consecutive frames, including color similarity and motion displacements is extracted. A decision tree utilizes these features to classify the states of the image acquisitions. For each classified state, the delay time between frames is calculated by parametric functions. A scheme selecting the optimal parameters set determined from assessments by physicians is deployed. Experiments involved clinical evaluations to investigate the effectiveness of this method compared to a standard-view using an existing system. Results from logged action based analysis show that compared with an existing system the proposed method reduced diagnostic time to around 32.5 7 minutes per full sequence while the number of abnormalities found was similar. As well, physicians needed less effort because of the systems efficient operability. The results of the evaluations should convince physicians that they can safely use this method and obtain reduced diagnostic times.

The Transition Edge Sensor (TES)-Energy Dispersive Spectrometer (EDS) is an X-ray detector with high-energy resolution (12.8 eV). The TES can be mounted to a scanning electron microscope (SEM). The TES-EDS is based on a cryogen-free dilution refrigerator. The high-energy resolution enables analysis of the distribution of various elements in samples under low acceleration voltage (typically under 5 keV) by using K-lines of light elements and M lines of heavy elements. For example, the energy of the arsenic L line differs from the magnesium K line by 28 eV. When used to analyze the spore of the Pteris vittata L plant, the TES-EDS clearly reveals a different distribution of As and Mg in the micro region of the plant. The TES-EDS with SEM yields detailed information about the distribution of multi-elements in a sample.