A sub-harmonic RF transmitter architecture with simultaneous power combination and carrier-leakage cancellation is proposed. It employs an 8-phase ring-type voltage controlled oscillator (VCO), sub-harmonic mixers, driver amplifiers, and a balun. A signal power is combined with its 180° phase-shifted signal through the balun. Simultaneously carrier-leakage generating in sub-harmonic mixers is canceled by its phase difference. The proposed transmitter achieved 1 dBm 1-dB output compression point (P-1dB) under 1.8 V supply and -40 dBm carrier-leakage in 5 GHz band.

A 10-GHz sub-harmonic Gilbert mixer is demonstrated in this paper using the 0.35 µm SiGe BiCMOS technology. The time-delay when the sub-harmonic LO (Local Oscillator) stage generates sub-harmonic LO signals is compensated by using fully symmetrical multiplier pairs. High RF-to-IF isolation and sub-harmonic LO Gilbert cell with excellent frequency response can be achieved by the elimination of the time-delay. The SiGe BiCMOS sub-harmonic micromixer exhibits 17 dB conversion gain, -74 dB 2LO-to-RF isolation, IP1 dB of -20 dBm, and IIP3 of -10 dBm. The measured double sideband noise figure is 16 dB from 100-kHz to 100-MHz because the SiGe bipolar device has very low 1/f noise corner.

An even harmonic quadrature mixer (EH-QMIX) with a balanced configuration is proposed for a direct conversion receiver. The unit even harmonic mixer (EHMIX) used for I/Q paths consists of two anti parallel diode pairs (APDPs) and a pair of diplexers. When the second harmonic of LO (2LO) from the LO section is applied to the LO port as a spurious component, a conventional single-ended EHMIX using APDP converts the 2LO leakage from the LO section into the baseband and the d.c. offset and the self-detected LO noise arise at the baseband degrade the sensitivity. This proposed balanced EHMIX configuration can cancel out the 2LO leakage in itself. Therefore, the d.c. offset and the LO noise are significantly suppressed and the degradation of the sensitivity can be avoided. The suppression characteristic of the d.c. offset and the LO noise are verified by the simulation and the measurements. By using this balanced configuration, the fabricated EH-QMIX achieves wider frequency band characteristic than that of the single-ended EH-QMIX, and it shows 20% relative bandwidth at L-band.

This paper presents an even harmonic quadrature mixer (EH-QMIX) with a simple filter configuration and an integrated LTCC module including LNAs, band rejection filters (BRFs), and the proposed EH-QMIX for W-CDMA direct conversion receiver (DCR). Since the DCR has no spurious responses, a BRF instead of a high-Q band pass filter can be applicable for eliminating undesired signals and it can be built in the LTCC substrates easily. As LO frequency is half of RF frequency in the EH-QMIX, diplexer can be composed of simple filters and it can be also integrated in the substrates. As a result, the whole RF circuits of the EH-DCR using a proposed EH-QMIX are integrated in the LTCC module and miniaturization of the receiver is achieved. Moreover, in order to suppress the degradation of the amplitude and the phase imbalances in the quadrature mixer caused by interferences of signals, RF characteristics of the circuits in the mixer such as reflection coefficients, isolations are discussed. A developed LTCC module shows good performances for W-CDMA direct conversion receiver.

This paper describes a millimeter-wave pulse transmitter with a 38 GHz-band Voltage Controlled Oscillator (VCO) and a 77/38 GHz-band harmonic mixer. This harmonic mixer works as both of a pulse modulator and a multiplier. This configuration of the transmitter is very simple, and can be applied to high-speed pulse modulation like Ultra Wide Band. By using the harmonic mixer, furthermore, a fluctuation of the load impedance of the 38 GHz VCO can be reduced. Compared with the conventional configuration, the required amount of isolation between the VCO and the load has been able to be reduced by more than 30 dB as a result of the experiment in a millimeter-wave band.

Beam control using active antenna arrays with self-oscillating harmonic mixers has been investigated. The active antenna is composed of a patch antenna receiving RF signal and a parallel feedback type oscillator which operates as the self-oscillating harmonic mixer, and down-converts the received RF signal into IF signal. The mixer has two ports for local oscillating (LO) signal. One is an output port extracting the LO signal. The other is an input port for an injection signal to synchronize the local oscillation. The mixers can be coupled unilaterally without other nonreciprocal components by connecting the output port to the input port in the next mixer. In the unilaterally coupled array, the phase differences of the LO signals between the adjacent mixers can be varied without phase shifters in injection locking state by changing the local free-running frequencies of the self-oscillating mixers. The receiving pattern can be controlled by combining the IF signals from the individual active antennas, which have phases associated with the LO signals. The IF is difference between the RF and double of the LO frequency so that arbitrary phase differences from 0 to 2π radian can be provided to the output IF signals. The experiments using the two- and three-element arrays demonstrated beam control capability.

An even-harmonic mixer using a bipolar differential pair (bipolar harmonic mixer;BHMIX) is theoretically analyzed from the direct conversion point of view; i.e, conversion gain, third-order input intercept point (IIP3), self-mixing induced dc offset level, and second-order input intercept point (IIP2). Also, noise are analyzed based on nonlinear large-signal model, and numerical results are given. Noises are treated as cyclostationary noises, thus all the folding effects are taken into account. Factors determining IIP3, IIP2, dc offset, and noise are identified and estimation procedures for these characteristics are obtained. For example, design guidelines for the optimal noise performance are given. Measured results support all the analysis results, and they are very useful in the practical BHMIX design.

A fully differential direct conversion receiver IC for W-CDMA is presented. The receiver IC consists of an LNA, a quadrature demodulator, low-pass filters (LPFs), and variable gain amplifiers (VGAs). In order to suppress DC offset, which is the most important issue in a direct conversion system, an active harmonic mixer is applied to the quadrature demodulator. Furthermore, a receiving system, including the LNA and an RF filter, adopts a differential architecture to reduce local signal leakage, which generates DC offset. Performance of the entire receiving system was evaluated and DC offset in steady state was measured at only 40 mV. Moreover, DC offset variation at the LNA gain change, which has the largest affect on the receiving performance, was limited to 70 mV, which is less than -10 dB compared to desired signal strength. It was confirmed by computer simulation that the DC offset variation at the LNA gain change did not degrade bit error rate (BER) performance at all.

This paper presents an even harmonic mixer using self-biased anti-parallel diode pair (APDP). A proposed self-biased APDP is composed of a pair of diodes and self-bias series resistors. At high LO injection level, rectified current is generated by the diodes and reverse voltage is applied to the diodes by the self-bias resistor. Therefore, rapid degradation of conversion loss at high LO input level can be avoided. The effect of self-bias resistor is explained by using simplified behavior model and harmonic balance method, and is evaluated by the measurements of an L-band even harmonic type direct conversion mixer.